Electronics Forum | Thu Aug 12 12:50:14 EDT 2021 | jamesatqkits
Hi Bukas, Err 22 shows up on the Panasonic motor driver in the back. I purchased this machine used. I have never had it operating in my shop. I checked the output of the transformer, 110 V output is 97 220 is 197, so I checked my input its 200 (machi
Electronics Forum | Mon Apr 19 01:36:55 EDT 2010 | jola
Been a while since I used those machines but I found a list on how it was on ours anyway: MV2-F,C: F8-F1-F7-SHIFT-M-V MPA-V: F8-F1-F7-SHIFT-M-P-SHIFT-A-SHIFT-V MPA-G1: F8-F4-F7-SHIFT-M-F7-P-F7-SHIFT-A-F7 Always start from the main "run" screen. Go
Electronics Forum | Thu Mar 30 03:45:04 EST 2006 | dd
Hi all, Can anyone explain the main difference between using a 45 degree squeegee angle over a 60. thanks in advance d
Electronics Forum | Wed Dec 01 10:26:10 EST 1999 | Dick Casagrande
My company is in the process of determining whether to setup an in-house SMT line. We presently do thru hole assembly and subcontract SMT boards which are growing in number. The economics are not my main concern now. The intangibles, i.e., control, l
Electronics Forum | Fri Jun 08 08:53:08 EDT 2001 | onset
Hi our company is currently using a water soluable paste. We have heard that no-clean solder paste has gotten alot better over the years and are thinking about making the switch. Our main concern is that our solder joints will not look as good as t
Electronics Forum | Tue Mar 20 09:35:30 EDT 2007 | ck_the_flip
I know a guy who pronounces solder (SOW-DIR), and dross (DROSE). Maybe, as the other guy says, your customer is from South Boston... but here's the "dictionary definition". Main Entry: sol�der Pronunciation: 's�-d&r, 'so-, Britain also 's�l-d&
Electronics Forum | Thu Mar 22 17:03:59 EST 2001 | williamh
I have been using an MPAV and MVIIF for about 3 1/2 years and have had some difficulties, mainly with the MPAV. After only 2 1/2 years of use we had to replace the laser because we were having alot of QFP's being mismounted. That was an $8,000 expe
Electronics Forum | Fri Jan 10 00:56:53 EST 2003 | fastek
You really must be on a tight budget since most people will pay YOU to take these models off their hands. What is your budget for capital equipment? Zero? That said, I think you would be better served to step up a generation and look at MPA-3's inste
Electronics Forum | Mon Mar 09 12:52:38 EDT 2015 | brianbrl
Hi, I had Assembleon machines for many years, and worked through a total of nine of them. Three years ago we began to look at the short-comings we had, based on the machines capabilities. We started to look for a new SMT platform that could improve
Electronics Forum | Wed Sep 26 11:42:19 EDT 2012 | comatose
I have an ap-25 and wish i had gotten the UP-2000 instead. How's that for an answer? The main difference is that the ap-25 uses linear motors and air bearings, whereas the up-2000 uses ball screws. The linear motors are faster, but the whole thing i
.gif)
