Electronics Forum | Tue May 22 18:21:15 EDT 2001 | davef
Again not quite what your looking for, but close, consider IPC-2221, Generic Standard On Printed Board Design, Para. 4.4.4 for minimum requirements for edge board connectors, as a baseline.
Electronics Forum | Tue May 29 20:22:19 EDT 2001 | davef
Well, no fault with your calculations from here. They appear to be correct. [Logic doesn't appear to be off to far off base, either. An epiphany, eh?] As mentioned in an earlier posting on this thread, consider following the recommendations of IP
Electronics Forum | Fri Sep 18 00:39:23 EDT 2009 | rohitfast
Hi Davef & Mikes, Thanks for the response. I am agree with both of your point. If the component bosy will be fall in Coductive or dissipative range, there are chances of shorting. Other thing in ESDS:2020 8.3 para is saying to keep away all the insul
| 1 |
