Electronics Forum | Wed Jan 05 11:53:28 EST 2000 | Dave F
Josue: Many variables, which you control affect paste height, but paste height is not (or correctly shouldn't be) the issue. Paste volume is where you should focus your attention. Check the archives Good luck. Dave F
Electronics Forum | Tue Apr 06 16:14:16 EDT 1999 | Dave F
| I need help in finding solder paste measuring equipment. | Cuch: What aspect about paste are you trying to measure? 1 Paste qualification? 2 Incoming quality? 3 Print volume? Dave F
Electronics Forum | Sun Aug 25 07:15:55 EDT 2002 | cnoonan
What are the industry standards for eutectic solder-paste in conjunction with the life span of solder-paste. What is the recommended duration of solder-paste on a printed circuit board. Example: You print a board, how long can it sit before runnin
Electronics Forum | Wed Jun 11 08:24:37 EDT 2003 | davef
Please help us understand better what you seek. Is it: * Cleanable low residue solder paste * No-clean solder paste * Someother paste
Electronics Forum | Mon May 03 15:39:05 EDT 2004 | Joe A.
Can anybody tell me which is better; to paste to BGA or to paste to PCB? What are the pitfalls when pasting to BGA?
Electronics Forum | Fri May 07 17:04:02 EDT 2004 | davef
Either method is acceptable: * No IPC approved method * Applying flux only is easier than applying paste * Paste gives a higher stand-off, which should improve reliability
Electronics Forum | Wed Feb 09 04:41:16 EST 2005 | dhanashekar
we are storge the soldering past as per the manufacture sefaction of arround 5deg before the using the paste we remove the paste from the storge and keep the paste in the room temp and then used. THANKS for the your soulation if ane other sulation pl
Electronics Forum | Thu Apr 21 08:45:53 EDT 2005 | davef
Top 10 products relating to solder paste are: * Printer * Stencil * Stencil storage rack * Squeegee * Squeegee holder * Under stencil wipe * Under stencil cleaning fluid * Stencil cleaner * Dispenser * Paste stirrer * Used paste / empty paste contain
Electronics Forum | Fri Apr 29 08:32:17 EDT 2005 | jdengler
I have never frozen solder paste so I'm not sure if it will work. Our paste manufacturer does caution against freezing of the paste but do not say why. Jerry
Electronics Forum | Tue Jun 28 02:37:17 EDT 2005 | grantp
Hi, Check to make sure your paste is not dried up, and it should roll across the stencil, not slide. Also, if your running in a cold environment, then that can stiffen up the paste, and it will still to the blades, and not roll over the stencil corr
.gif)
