Electronics Forum | Mon Jul 12 14:00:37 EDT 2004 | blnorman
We've been using lasers to mark barcodes on our boards for some time now. We use a CO2 laser to burn through the solder mask on most of our boards. The machine is enclosed so the operators aren't exposed to the laser. The laser is also mounted on
Electronics Forum | Mon Jul 12 11:11:25 EDT 2004 | Stefan
For laser marking you don�t require as powerful lasers then for cutting. A 20 Watt laser diode does already a good job. Because of the safety requirements the laser operates in an enclosure, which means more $$$ if you want to use the laser in line
Electronics Forum | Sun Oct 11 10:00:11 EDT 2015 | brockparry
if you are facing a problem to send the data to your machine then you must check the driver part of your machine if you are sending it through any software. Also check the power status of the machine. You can also go for one simple method by doing Re
Electronics Forum | Sun Feb 03 08:46:34 EST 2019 | dfl
SOLVED The LED/phototransistor was a little of the center on the "index wheel" (don't know a better name, its the gear that pulls the component strip). The wheel works with a LED from one side and a phototransistor from the other, through a hole on
Electronics Forum | Mon Jan 21 07:01:02 EST 2013 | ericrr
I can not believe this, We get back from Summer holidays turn on the first machine Juki KE750L goes to do a home and before the head moves, Error notice: rear feeder rise error, I go around the back, nothing out of place. but notice the receiver end
Electronics Forum | Sat Sep 28 15:58:38 EDT 2013 | sonavc
Hi. 'm new to this Fuji CP3, I bought this machine in working condition ( I saw it ran, but I forgot to check the board in and out ).... Moved to my location, Problem: When the board is trying to load to the X-Y table, it passed the conveyor B but
Electronics Forum | Tue Nov 15 23:03:07 EST 2011 | supse
Hi I have a problem with one of our MY12 machines, the machine stops very often (approx. 10-20 times a day) writing the following error message : f-mot-msetdyn hydra theta/205(f-hrdw-3). We then have to reinitialize the machine to continue productio
Electronics Forum | Wed Sep 30 20:35:51 EDT 2020 | erici
Hi all, was wondering if you have any ideas on how to correct the problem we are encountering with our S25 machine. The machine is giving an X-axis counting error at gantry 1. I replaced the x-axis linear reader and the linear scale as well, but st
Electronics Forum | Fri Sep 14 04:11:16 EDT 2012 | mili
Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leght
Electronics Forum | Fri Jan 10 03:33:42 EST 2014 | hans88
hello people, we have a my12 wich has a problem it gives the following error during hardware initialization: F-MOT-MSETDYN Y/1236 :Motor amplifier channel a error. after this error it says hardware initialization failed. this prevents us of using
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
