Electronics Forum | Sat Dec 21 13:03:52 EST 2002 | V.RAMANAND KINI
Hi to all, All of us are familiar with the conventional way of making PCB...I mean...photo tools/expose/develop/etch/plate etc., These involve lots of chemicals and the work place is toxic. I have a small PCB with just two curves (circuit tracks)and
Electronics Forum | Mon Dec 30 10:44:13 EST 2002 | V.RAMANAND KINI
Can you pls. suggest some CNC machines (small, table top) to do this by miling the copper? thanks
Electronics Forum | Sat Jun 27 11:47:58 EDT 2009 | grantp
Hi, That's an interesting idea, and should work well. Has anyone used this process before? If you were careful, you could even reflow the board with a heat gun, but at the very least, you would only need a simple batch reflow oven. Someone should m
Electronics Forum | Thu Dec 26 13:02:15 EST 2002 | MA/NY DDave
Hi Again, As I was thinking about this, I remembered another unconventional way that I was told about from one of the starters of this technology. Now I don't think anyone would use this technique anymore, yet here it is: Press Cutting and Pushing
Electronics Forum | Tue Jun 30 12:08:55 EDT 2009 | wrongway
sipad does work we used it on one assy it had a very fine pitch part on it and at that time our dek 260 wasn't up to the task along with our 8 mil stencils. we had no problems with it it was sticky enough to hold the parts on thur all smt machines.
Electronics Forum | Tue Dec 31 01:58:19 EST 2002 | MA/NY DDave
Hi Sorry, even though I have seen a machine in action by a test engineering department years ago, and remember some advertisements since then, and maybe have seen one at a show, I don't remember the names of the companys. If I had to I could probab
Electronics Forum | Sat Jun 27 00:23:26 EDT 2009 | grantp
Hi, This is easy. If your just doing prototypes, then you could get by with a syringe of solder paste and a hear gun. You can put down a little solder paste on each page and then place the passives and heat gun the board. If you have other active p
Electronics Forum | Fri May 02 08:43:48 EDT 2008 | chineechooze
I am Indian and a guru in industry so let me answer questions one by one 1. What is the future status on thru-hole boars, are they going to stay for long time on a market? TRU-HOLE MAKING A BIG COME BACK. THEY COME IN THE LEADFREE NOW. 2. Which
Electronics Forum | Fri May 02 00:22:15 EDT 2008 | deni
Hi everyone, I am an Electrical Engineer (BT). I am interested to start my own business on building up electronic boards (thru-hole and SMT). I have never done this work before except practice in college. My questions are: 1. What is the future sta
Electronics Forum | Mon Dec 30 16:49:06 EST 2002 | genny
in a Canadian magazine, I saw an ad for a benchtop PCB prototyping system. I can't tell you if they are any good, but it might be what you are looking for. The company is LPKF Laser and Electronics. Website: http://www.lpkfusa.com
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)