Electronics Forum | Thu Oct 30 09:15:20 EDT 2008 | kingshar
Hi, Hi, 1) Can anyone tell be what is the acceptable manufacturing tolerance from stencil to PCB . 2) what are the methods we can avoid that. 3) What is the method to avoid PCB shrinkage. 4) How can we correct shrinkage 5)Is there any standard gud
Electronics Forum | Fri Oct 31 07:15:39 EDT 2008 | kingshar
Hi Andrzej, Thank you for your suggestions. The Link which you referred is really informative. Thanks and Regards, Kingshar
Electronics Forum | Fri Oct 31 08:02:14 EDT 2008 | davef
Here is some more reading on stencils for you: http://www.smtinfo.net/Db/_Stencil%20Printing.html
Electronics Forum | Fri Oct 31 06:55:35 EDT 2008 | andrzej
Answer on point 2 - I understand you send him gerbers of single PCB (?). In most cases you have panelized PCBs so to avoid problems with stencil first you should order PCBs and ASK your PCB supplier to send you back his gerbers of panel. There are so
Electronics Forum | Mon May 07 16:07:05 EDT 2012 | davef
Start with targets based on the stencil thickness (for height) and stencil thickness times the aperture size (for volume). * Set reasonable upper and lower control limits (+ 25% and –25 % of the targets, for example). * Next, check the printer set-u
Electronics Forum | Wed Jun 07 22:33:50 EDT 2006 | Bolos
first: what is your problem after reflow? second: a good rule of thumb is a tolerance of 1 mil. for example..if you got 5 thou stencil thickness then your range of thickness is 6-/+1 thou.. then you just improve after you get your height data and ana
Electronics Forum | Thu Jun 09 07:02:02 EDT 2005 | ajaydoshi
1. We do have PCB with 0402 component, Micro BGA ( 0.5mm pitch , 0.25 mm pad size ). PCB thickness is 0.8mm. What stencil thickness we should use. PCB size 40 mm X 60 mm 2. We have EKRA E4 , What will be optimum setting for above. Pressure, Scquge s
Electronics Forum | Wed May 17 11:00:00 EDT 2000 | emmanuel
Has somebody yet process pcb (FR4) with a thickness of 0.8 mm ? Thank you for all kind of responses.
Electronics Forum | Fri Oct 03 07:49:18 EDT 2003 | mk
Mask Musings. Soldermask (SM) and its functions have changed and evolved over the years. As an ex-solder mask applicator, I can remember screening Colonial High Gloss Epoxy soldermask on boards back in the early 80's, ending up with a thickness that
Electronics Forum | Thu Jun 09 13:30:34 EDT 2005 | PWH
I would suggest 7mm thick "Durostone" as a carrier material. Cut lip/pocket for PCB so it is 0.05" thinner than thickness of PCB. Allow 0.010" gap on all sides of PCB. Machine lip to width between 0.050" and 0.100" to support under perimeter sides
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
