Electronics Forum | Wed Dec 15 04:59:40 EST 1999 | Joshua Hall
Hello KA, When producing in kind of PCB product you have to base much of your decision on cost effectiveness, time, and quality. In order to get the best of all three you have to decide which you want to be your top priority. By adding an epoxy to
Electronics Forum | Thu Apr 19 10:59:05 EDT 2007 | peteb
Greetings, Is there a Mil Spec or IPC spec on how many times you can wave solder a PCB? I did a search on this forum with no results. Common sense says two or three times. I need documentation.Thanks for any info.
Electronics Forum | Fri Aug 07 15:56:56 EDT 2009 | davef
Well, since you've gotten no takers, we'll launch in to this with careful analysis and introspection, fully aware that we're likely to get 'blasted' for any number of reasons. The most critical parameters to monitor for proper wave solder machine pr
Electronics Forum | Wed Jul 29 03:32:57 EDT 2009 | dilogic
We recently started to use wave-soldering. As total newbies in that field, we got successful results most of the time. Howewer, this batch of PCB's had a lot of resdiue, as shown on the picture. Most of it is most likely flux, but on some areas even
Electronics Forum | Tue Jun 10 16:51:19 EDT 2003 | davef
Develop your recipe wave soldering exactly as you developed your recipe for reflow soldering. The only difference is that instead of using your paste supplier's recommendations as the starting point, use your flux supplier's recommendations as a bas
Electronics Forum | Thu Apr 19 11:45:34 EDT 2007 | Cal
Hi PeteB... I dont think you will find any Specs...but that I do not know. What I do know is it depends on the make up of your PCB and Components. Obvious haveing components that may be sensitive to heat the less you want to run or pass through. Re
Electronics Forum | Thu May 06 19:56:30 EDT 2004 | bruceatknoll
Here is some more info with regarding my Wave. 1. PCB .065" thick 2. leed length .20" (.135" protrution) I know this is high but we use many thousands and cutting each is not practical. 3. no clean flux by way of foam fluxer 4. wave machine is a HOL
Electronics Forum | Wed Aug 30 09:56:37 EDT 2000 | NLykus
Hi Ramon, We have had this problem before on our Seho Wave Solder Machine. We are currently using a spray fluxer as well. By imersing the PCB into the flux you stated you are getting good results. What you need to do is check your spray patter
Electronics Forum | Thu Oct 07 06:02:38 EDT 1999 | Wolfgang Busko
| | | | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life
Electronics Forum | Wed Jun 18 19:26:39 EDT 2003 | gregoryyork
Rules of thumb :- 1. Never over flux - not necessary and waste's money. Never top flux neither 2. Top Board temp. around 70C - 105C or there about's pending what laminate you use. Obviously the more flux you apply the higher heat required/denser PC
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.png)
.gif)
