Electronics Forum | Sun May 16 00:07:58 EDT 2010 | tpappano
I have a Philips CSM84VZ. There are offset calibrations that compensate the X and Y distances from the camera to the heads and the beam pointer. Perhaps yours is similar and just needs a small Y adjustment for the beam pointer.
Electronics Forum | Fri May 14 11:14:57 EDT 2010 | thanh
wow, no one can figure out why it doing that????
Electronics Forum | Wed May 05 16:12:30 EDT 2010 | thanh
after calibration, now i'm having an issue that placement between lazer and camera off about .5mm on the Y mount. if parts go to camera, the placement are good. but parts that placing with lazer it off about .5mm at Y for all rotation. anyone seen t
Electronics Forum | Tue Jun 01 15:06:40 EDT 2010 | thanh
I did. Nothing change. I can go in mount feed back and increase .5mm for all rotations(Lazer mount feed back), then it work. But all my parts go to camera will be off the oposite way.
Electronics Forum | Sat May 29 02:20:08 EDT 2010 | vinitverma
Mch Adjust > Adjust Target > Laser Unit > Nozzle Position. Here the laser will automatically detect the centre of the nozzle. Remember - It'll give you the option of using a component for the test but DON'T use any component. Let it detect the centre
Electronics Forum | Mon Nov 12 08:56:32 EST 2007 | chrisruizuci
im looking to buy a pick and place machine and right now the two that have caught my eye are the Philips Topaz and the Mydata TP9. just tring to figure out which is better?
Electronics Forum | Mon Mar 03 18:28:02 EST 2008 | wayne123
I am looking for a philips Saphire. I haven't been able to find one in the states for sale. any help would be appreciated. Thanks,
Electronics Forum | Mon Nov 12 11:50:51 EST 2007 | chrisruizuci
Smallest is 0603 and some 0402 High Mix PCB�s Low Volume
Electronics Forum | Thu Nov 15 09:18:25 EST 2007 | davef
Steve: In comparing TP9 with Topaz, what consideration did you give to tear-down / set-up time?
winsouce.jpg)
