Electronics Forum | Sat Jul 08 09:19:53 EDT 2006 | Larry
Samsung vs. Assembleon We currently have both Samsung/Dynatech and Assembleon Equipment. We started with two Samsung machines but the support, flexibility, component range, accuracy and speed of their machines just wasn�t there. The difference betw
Electronics Forum | Fri Jun 19 06:18:41 EDT 2020 | vinitverma
Look for Philips Emerald (3 Phase supply) or it's predecessor Eclipse (single phase supply). It has 2 heads, Laser + Vision alignment (no mechanical alignment).
Electronics Forum | Mon Dec 29 16:49:57 EST 2014 | emanuel
Hi Rob, I am writing this reply as an update. Unfortunately I got your recommendation a bit too late, I contacted Count-On Tools and ordered from them a custom made nozzle for the Emerald. $300 paid for the "pleasure", everything could be OK if it w
Electronics Forum | Tue Aug 17 09:49:59 EDT 1999 | Earl Moon
| Looking for users of the Emerald pick and place.Comments on that equipment would be greatly appreciated. QFP and micro-BGA placement, idiot proff software etc. | | We just got a good offer to use that equipment for our training center instead of o
Electronics Forum | Mon Jul 01 03:40:02 EDT 2019 | robl
Hi Janet, You could pick up an Emerald very cheaply these days, which is very similar except has 2 heads and can go to 15-17mm high. May be cheaper than trying to modify a topaz & vision system. Same software, feeders etc.
Electronics Forum | Fri Mar 15 21:20:18 EDT 2024 | compit
Check out Yamaha - also old. A large number of parts (the same machines under the Assembleon, Philips brand), cheap feeders, many parts suppliers. Models from 2 to 16 heads, e.g. Emerald-X can accommodate 84 INDEPENDENT 8 mm feeders.
Electronics Forum | Fri May 10 01:42:13 EDT 2019 | vinitverma
A Table is something that you can ignore right now. It is significant only in case of dual table machines such as Sapphire or Sapphire-X which have A and B tables (two independent PCBs being handled at the same time). In case of Topaz or Topaz X or E
Electronics Forum | Wed Jan 17 13:33:23 EST 2007 | slthomas
We're in the process of trying to select a rebuilt, refurbished, or well serviced flexible placer, something that's capable of placing in the neighborhood of 10k and up. We're a high mix low volume shop so easy setups is key. I'd be looking at a MY-9
| 1 |
