Electronics Forum | Fri May 09 09:52:33 EDT 2014 | aj
http://www.murata.com/products/micromechatronics/feature/actuator/index.html not much info out there about them - will contact supplier but interested to know if anyone works with these .
Electronics Forum | Tue May 20 20:18:23 EDT 2014 | g2garyg2
Yes we solder them for a variety of customers. Your inquiry is not specific to what you are seeking info on.
Electronics Forum | Wed May 21 02:15:26 EDT 2014 | aflex
Not very sure of. But can help you in getting the right actuators. Contact this company http://www.venturemfgco.com/. They got a good name in actuator manufacturing. For any PCB requirement contact us for the best deal.
Electronics Forum | Wed May 21 03:59:05 EDT 2014 | aj
Hi, If you can advise any assembly issues or concerns regarding this type of part and also... 1 - Can you confirm that they come in tape & reel format? 2 - Is it a requirement to have a glue dot in the centre of the pcb pads? Thanks, AJ...
Electronics Forum | Tue Nov 17 15:27:20 EST 1998 | Barry Kauffman
Can someone please tell me where I might find detailed information on the processing of a double-sided flex circuitry design. I am looking for specifics such as methods of fixturing,printing,placing and reflowing.Things to keep in mind when processin
Electronics Forum | Sat Jun 16 09:18:56 EDT 2007 | fasterstill
Hi Guys Looking for someone to build me a circuit to drive a piezo. Requirments: up to 30v output from 12v supply, prob tranny on output. frequency range 15-38khz, only one output frequency required at a time but the ability to tune to anywhere betw
Electronics Forum | Thu Nov 19 17:36:03 EST 1998 | Christopher Lampron
| Can someone please tell me where I might find detailed information on the processing of a double-sided flex circuitry design. I am looking for specifics such as methods of fixturing,printing,placing and reflowing.Things to keep in mind when process
Electronics Forum | Sun Aug 02 21:59:37 EDT 2009 | hohk
Wow! Thanks Jim!. When the ejector pin hits the piezo ceramic sensor, the sensor will produce a voltage difference between the top and bottom surface(that's why i need to connect the tracks on both sides) which i will measure. The sensor does not ne
Electronics Forum | Sat Dec 30 23:39:25 EST 2000 | John Litva
I'm hoping someone on this forum can ID this component. This is a Piccolo board used in an 8 ounce micro electric helicopter. This board has (2) 5 amp speed controls and a single rate piezo gyro to stabilize the helicopter in flight. My father's P
Electronics Forum | Wed Mar 02 05:02:46 EST 2005 | prabhu_jude
Hello, We are using a film piezo electric sensor to deduct and measure vibrations. A long twisted pair shielded cable is used to connect the sensor to the signal conditioning unit (the signal conditioning unit has to be kept at a distance from the se
.gif)
