Electronics Forum | Mon Mar 13 05:29:08 EST 2006 | hitechsc
Hi just to clear a few things, We produce the nozzles and the parts are manufactured in two stages, CIM and plastic injection moulded, we designed the rear end of the ceramic tip with spikes so when the secondary operation on plastic over mould the p
Electronics Forum | Fri Oct 14 12:03:32 EDT 2011 | fborja3
I want to start an assembly that may require use of SMT machines such as SMT assembly, bond wire, Xray and PCB fabricator machines. I apologize I am not to savvy with the technical names such as the above but I just want something not to costly or e
Electronics Forum | Wed Jan 13 15:43:00 EST 1999 | Dave F
| How is everybody? | | I was asked about any problems that would be associated with having a plastic casing injection molded around an assembled PCB. I am not sure if injection molded plastic has to be hot, I am assuming so (can they use epoxi
Electronics Forum | Tue Jan 12 17:03:59 EST 1999 | Ryan Jennens
How is everybody? I was asked about any problems that would be associated with having a plastic casing injection molded around an assembled PCB. I am not sure if injection molded plastic has to be hot, I am assuming so (can they use epoxies?).
Electronics Forum | Sun Dec 26 16:13:49 EST 2010 | sam
Hi, Here is a brief synopsis of PNC - PNC has been a quality manufacturer of rigid printed circuit boards for 40 years. Located in Nutley, NJ, we are the largest shop in the North East. PNC provides complete turnkey jobs from design, PCB fabricatio
Electronics Forum | Mon Apr 03 09:25:59 EDT 2017 | Rob
Use a router with fiducial correction? in reality if you are putting a PCB in a plastic enclosure then the injection moulding is going to have far greater tolerances than a laser or router depanelised PCB is. Also, if our laser markers are anything
Electronics Forum | Sun Mar 06 17:10:41 EST 2005 | Darby
The manual gives you a fair idea here. Reference for the Yamaha manual is THE6006 - I don't know if Philips is the same. Cause is either overload or overcurrent. The manual suggests that you can tweak the trimmers on the driver board but these are us
Electronics Forum | Wed May 01 20:48:44 EDT 2002 | ianchan
Hi, I agree that professional-role accountability (QA, Process, Manufacturing, Materials, etc...) is of paramount importance. in fact nothing yielding results, gets to be done without followup in continual improvement action unless individuals are
Electronics Forum | Tue Jul 19 09:06:00 EDT 2016 | davef
We used to use those, back in the bad old times. basically, it's a router with a blade on it that is used to trim the leads of PTH components that are mounted on boards. Nasty process. Difficult to control. Messy, firing cut leads all over the plac
Electronics Forum | Thu Sep 09 07:46:04 EDT 2004 | cyber_wolf
Does anyone know of a better way to inject grease into the cam follower bearings on top of the turret on a CP43? Fuji wants you to use a plastic hypodermic syringe.(It works, but it is kinda a pain in the a$$)
.gif)