Electronics Forum | Fri Apr 24 14:18:40 EDT 1998 | Scott Davies
I realize this is a SMT forum, but I have another problem related to electronics assembly and hope there will be someone out there that can save my life (this time). We build quite a few VME assemblies to which we attach a SAM board. Fairly standard
Electronics Forum | Tue Apr 28 10:09:59 EDT 1998 | Scott Davies
| | Where can I find pliers to accept a round standoff? | Scott: Two ideas come to mind: | 1. change the stand-off round to to a hex shape | 2. if you must use the round shape, go to Sears, buy a "robogrip" and a pack of the platic inserts that fi
Electronics Forum | Mon Apr 27 06:46:39 EDT 1998 | Greg Curler
| I realize this is a SMT forum, but I have another | problem related to electronics assembly and hope there | will be someone out there that can save my life (this | time). | We build quite a few VME assemblies to which we attach | a SAM board. Fai
Electronics Forum | Mon Apr 27 11:04:12 EDT 1998 | Dave
| I realize this is a SMT forum, but I have another | problem related to electronics assembly and hope there | will be someone out there that can save my life (this | time). | We build quite a few VME assemblies to which we attach | a SAM board. Fai
Electronics Forum | Mon Mar 24 11:09:43 EST 2003 | rdr
Excelta has some Pliers that may do this. I know that they have one for a 3-lead offset. You may try this number for more info. Ktec 18004685832 www.ktec-sys.com
Electronics Forum | Thu Jan 12 22:51:12 EST 2006 | davef
We think if you follow your suppliers instructions, you should be OK. Why not have your quality people rip a couple of the soldered heat sinks from the board to assure themselves that your soldering process is adequate? Give them a pair of pliers a
Electronics Forum | Wed Jun 10 13:42:22 EDT 1998 | FRANK
| We're running into problems with board damage (broken traces, solder shorts) due to pliers and other bizarre tools being used for depanelization. I need some sort of fixture for this. A delrin plate with a slot cut to the correct depth and width mi
Electronics Forum | Tue Mar 22 07:39:05 EST 2005 | davef
There is no standard. This is a relative test. If you wish to do tests of this kind, we suggest to pay attention to the following points: * Shear strength of soft solder depends on the deformation speed applied. The faster the material is deformed t
Electronics Forum | Mon Mar 20 08:50:47 EST 2000 | Dave F
Scott: Pyros don't like to be heated, so soldering should be done as quickly as possible. Other tips are: * Keep pyro leads long. * Apply solder to the ends of leads. * Heatsink the lead, while soldering by holding the lead with a pair of pliers
Electronics Forum | Tue Nov 30 17:00:26 EST 1999 | Dave F
Listed in the archive are suppliers of lead forming equipment. Most have equipment that can do the stand-ups you require. Yes you may be able to find this used. Yes you may be able to find someone with that machine near you who after you buy the t
