Electronics Forum | Tue Jun 07 20:27:08 EDT 2022 | SMTA-64387687
The ribbon cables might be shorting. Have you replaced them?
Electronics Forum | Fri Jul 18 16:04:31 EDT 2014 | comatose
We had this. The anti-backlash nuts were binding. We took them apart, chased the threads with a tap and re-assembled with slightly less pre-load. Hasn't been a problem since.
Electronics Forum | Tue Jun 07 19:04:07 EDT 2022 | proceng1
IF the two are identical, swap the suspected bad one (#2) position 1, and see if the fuse blows before connecting the second one. Basically the same test process you describe, but swap the units first. See if the problem follows the card, or stays
Electronics Forum | Thu Jun 09 18:12:48 EDT 2022 | curtisp
These were all great suggestions and helped find the issue; we ended up replacing the Mot M board which made it work.
Electronics Forum | Fri Jul 18 10:10:21 EDT 2014 | proceng1
We've got an MPM Accuflex printer that generally works great, but we've had a recurring problem. The powered rail (rear rail) fails to initialize. Sometimes all it takes is restarting the machine to get it to work. At the suggestion of the repair
Electronics Forum | Mon Jul 21 11:01:11 EDT 2014 | dontfeedphils
I dealt with the same issue for a month or so. We jumped through a lot of hoops, replaced both lead screws, verified the motor was good, a ton of stuff. Ended up being an intermittent wire connection between the control board and the conveyor width
Electronics Forum | Mon Jul 21 06:18:15 EDT 2014 | digar
We had this. The anti-backlash nuts were binding. > We took them apart, chased the threads with a tap > and re-assembled with slightly less pre-load. > Hasn't been a problem since. > We had this. The anti-backlash nuts were binding. > We took t
Electronics Forum | Fri Jul 25 10:11:36 EDT 2014 | cgreiner
We also had this problem and found similar results with the anti-backlash nuts binding. We went through the process of cleaning the lead screws and the nuts which resolved the problem for about 6 months only to have it return. We learned that the
Electronics Forum | Fri Jul 25 10:13:01 EDT 2014 | cgreiner
We also had this problem and found similar results with the anti-backlash nuts binding. We went through the process of cleaning the lead screws and the nuts which resolved the problem for about 6 months only to have it return. We learned that the
Electronics Forum | Sun Jun 05 00:00:17 EDT 2022 | curtisp
We are having a problem right now where the machine won't load the circuit boards (mot m, y, z, etc) due to the machine blowing the fuses. This was diagnosed by one of our engineers to be a problem with this part: MyData MyCronic Booster BNB/NREG L-0
winsouce.jpg)
