Electronics Forum | Wed Feb 11 06:37:10 EST 2009 | reflowtechnologies
Please check the following: 1.Power supply. 2.SSR control power. 3.OTP or over temp protection at the software. Maybe you set it at low so it reads over temp even at lower temp. If still not ok you may check BTU service engineers. Brian Riggs
Electronics Forum | Sat Jan 09 13:42:54 EST 2016 | aemery
Bill, Did you ever get this issue resolved? Electrovert is more my cup of tea, but I have completed a couple of pot replacements on the Vitronics waves. I remember on one machine after the retrofit the we were testing the machine and everything dro
Electronics Forum | Mon Jun 29 19:36:08 EDT 2009 | proy
Are you sure it is the Z axis, and not the rotation, I had one machine which often did something similar, it would buzz loudly, especially if you touched or applied rotation pressure to the gear belt which rotates the head. It never caused any hard s
Electronics Forum | Wed Jul 01 13:41:25 EDT 2009 | jlawson
Are you sure it is the Z axis, and not the > rotation, I had one machine which often did > something similar, it would buzz loudly, > especially if you touched or applied rotation > pressure to the gear belt which rotates the > head. It never ca
Electronics Forum | Tue Jun 23 08:08:38 EDT 2009 | ptxems
We have a couple of Zeva/Juki PM570L's. One machine has developed a fault with the z axis motor. It is continually 'buzzing', we have checked and there is 24VAC on it. Although even on the other machine there is AC voltage on the motor. We have sw
Electronics Forum | Thu Feb 04 04:28:52 EST 2010 | mika
You don't by any chance have a s/w called Motion Control s/w? it's on 1-2 floppy diskettes and it will boot from it also. Normally only the UIC field engineers have/has? this. With this we can actually run each axis & valve or whatever independentl
Electronics Forum | Thu Feb 04 09:18:18 EST 2010 | mika
Problem! Then replace the motor! Why not replace be belt anyhow? How long was it since the last time you replaced any belt? Another thing you could also do; In the LP (Low Power) chassis lower front left, find the correct motor servo card and "Null
Electronics Forum | Mon Jun 19 12:42:16 EDT 2023 | daniel_stanphill
The my700 can dispense 1 million dots per hour. It's not an exaggeration either. It literally never stops moving, and is dispensing without contacting the board. It uses the same type of mathematical calculations that a plane dropping a bomb uses in
Electronics Forum | Fri Sep 07 15:19:42 EDT 2001 | davef
Watt tiepoo? [Cereally, you can usually fix typos after you post by using the P yellow �edit� button that shows when you are looking at your posting.] We�re had people on SMTnet that were washing their boards with a brush attached to the end of a ga
Electronics Forum | Wed May 06 08:15:39 EDT 2009 | xinxi
Hi all, I understand that this forum is more to surface mount discussion. But I am eager in sorting out the spray fluxer problem. Please provide me with any ideas that you think might cause it. I have a problem in starting up/initialising the wave
