Electronics Forum | Mon Jan 20 05:15:21 EST 2020 | bobpan
Hello, You have a tep initialize issue. Please contact me. If you need my email go to my website and i would be glad to help. www.precision-repairs.com Bob
Electronics Forum | Mon Jan 20 03:50:37 EST 2020 | falconex_technician
Hi, my company bough second hand pick and place as our second machine. After first transport after start just when initializing, It's showing problem with Z calibration. After second position setup and connect again after month, now showing &
Electronics Forum | Mon Apr 13 16:02:17 EDT 2009 | abdelga
Anyone with any thoughts (pro or con) for the following options for Quad, QSV-1 pick and place?: detachable feeder bases IQ system
Electronics Forum | Tue Apr 14 08:13:08 EDT 2009 | kpm135
If you plan on loading offline to get the most out of your machine time every day then they are a must. If you don't care about that and how long your change overs keep the machine down then I guess they don't matter.
Electronics Forum | Tue Apr 14 10:08:31 EDT 2009 | leemeyer
This probably goes without saying but in order to utilize the feeder carts you must have enough feeders to have a job running on the machine, and a job loaded and sitting on the feeder carts. Also the IQ system can only talk to IQ feeders.
Electronics Forum | Sun Feb 18 16:47:34 EST 2007 | darby
As I stated, the reply was direct from Indium, (thanks to Rich Brooks). The information regarding cool down rates should come from your paste supplier; not an oven supplier; not a generic article on lead free. I just went through the data sheets from
Electronics Forum | Fri Jan 18 09:34:06 EST 2008 | realchunks
Try lifting the part with a small piece of paper. I've seen caps that did this and giving the flux a way to vent out the top side of the board got rid of the blow holes. It'll take ya 2 seconds to to try - that plus the 3 minutes to wave solder.
Electronics Forum | Wed Nov 23 09:22:16 EST 2016 | hloranzo
on the quad Qsv1 plus the z1 board has a amber light not green ,,, swap the z2 board and still amber light help please
