Electronics Forum | Fri Dec 09 17:57:16 EST 2005 | mika
cameras > P2P (Part to Pad looking camera or upper looking camera) > front or rear >> select the corresponding camera that You have installed. After that: just save and follow the instructions on the screeen. By the way, an important thing is: You M
Electronics Forum | Tue Dec 21 17:15:49 EST 2021 | vtdivtecs
yeap I was able to figure it out and avoid my head being on a stick anywhere. if you log out of tpsys and into hw config you can turn off the hydra head there, then unplug the hardware and the machine will run. if you just disable it inside tpsys t
Electronics Forum | Tue Dec 21 16:59:59 EST 2021 | tey422
You should able to log into the TPsys to disable the hydra head. BTW, last time I work on the Mydata machine was about 15years ago.
Electronics Forum | Tue Dec 21 12:28:11 EST 2021 | vtdivtecs
hey all, I had a comically bad failure yesterday while working with my pick and place, a part got dropped at exactly the wrong moment and flung a bracket up into the tool path, severely damaging the hydra controlboard that is next to the x camera. T
Electronics Forum | Sat Sep 26 14:54:52 EDT 2015 | ercdave1
Hello, just a quick update on this issue. I disabled head 2 on beam 2 which was the second head I worked on, and left only active the head that I had work with first and ran dry cycle with. after disabling the head 2, the machine zeroed with no pr
Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Electronics Forum | Tue Feb 09 14:32:04 EST 2021 | bobpan
You have to disable some lines in the machine.cfg file. If you do this....save the original before modifying it. I think you disable the gantry/head and the mei for Gantry 2.
Electronics Forum | Tue Feb 09 10:34:53 EST 2021 | jamesn
Hello Gents I have a problem with the head on gantry 2. I think it needs replacing but in the meantime Can anyone on the forum tell me how to disable it so the machine will initialise and run gantry 1 Ive been told it can be done but they cant rememb
Electronics Forum | Tue Feb 09 14:53:50 EST 2021 | jamesn
Thank you bobpan much appreciated I will give it a go Regards James
Electronics Forum | Wed Feb 10 19:29:45 EST 2021 | bobpan
I found a proper procedure to do this. Its rather long. Go to http://www.precision-repairs.com and email me and i will send it to you. Bob