Electronics Forum | Thu Jul 06 08:16:53 EDT 2017 | claudea2
Hello, I have 3 Quad 4C one with Quad Align and 2 with the older lasers. All 3 machines have a placement offset issue. Every 4 or 5 boards one of the machines has a placement offset of about 10-20mills in one direction. A reset usually brings it back
Electronics Forum | Mon Apr 03 08:51:43 EDT 2017 | teslalab2
When you update a Quad to windows, they replace the epcu card with some other card, does anyone know the part number on that card? Thanks
Electronics Forum | Thu Jul 06 11:47:10 EDT 2017 | bobpan
Are you sure the board is clamping tightly. If it moves during a run this can happen. Before reseting the machine. Go and check your feeders. If they are off the same amount....then the machine truly has a drift in that axis...if the feeders are stil
Electronics Forum | Tue Nov 30 06:33:44 EST 2010 | jmw
If you are using the upward camera then you probably have to put in a placement offset for each head. This only effects upward camera placements...not quadalign. This is located in: 1. machine-calibration-camera lens 2. Choose upward camera2 under "
Electronics Forum | Thu Oct 01 13:04:57 EDT 2015 | ahanna
ahanna@lumitex.com Thank you very much I appreciate it!
Electronics Forum | Mon Sep 28 09:58:45 EDT 2015 | ahanna
Hello everybody! I'm working with a Quad 4000c that has been refurbished by PPM and need a little help with using the CAD feature. Is there anyone that can help me out by giving me a basic walk through of how this works? I'm not sure if this is valu
Electronics Forum | Thu Oct 01 12:37:54 EDT 2015 | deanm
If you are still looking for information I have a procedure that our company used that I could send you that should still work for the 4000C. Please post your email address.
Electronics Forum | Thu Jan 07 15:48:03 EST 2016 | ahanna
Hey everybody! So my Quad 4000c has been acting funny lately. When it goes to dumb a rejected part into the dump bucket it doesn't actually drop the component. This results in it trying to pick up another part with the previous part still on the nozz
Electronics Forum | Mon May 16 19:57:51 EDT 2016 | rx8pilot
I recently purchased some used ThinPRO precision feeders for my Quad IV-C (PPM 4000C). They are in great shape, but I do not know how to program them to index at 2mm Does anyone have experience with these that know how to program them? I can only go
Electronics Forum | Thu Jun 25 21:06:38 EDT 2020 | jshepard77
I have an old Quad 100 pick and place from the 90's that currently is not working. We bought the machine for basically nothing. The reason we bought it was that it had a ton of feeders that work with a 4000C machine that we have. Before I take thi
.gif)
winsouce.jpg)