Electronics Forum | Wed Jan 15 11:18:51 EST 2020 | avillaro2020
Hi Evtimov, Thanks again! The solder wicking/open solder joint is not actually gross rejection, it is only a few and appeared random (difficult to trend the location of the opens), what is perflexing is that i have this 1 or 2 open solder joints sur
Electronics Forum | Tue Jun 20 16:41:12 EDT 2017 | kkrestchmer
We have a Speedline Electrovert Bravo 8 reflow oven. We have issues where we get a "thermal runaway HTSC trip" error and the oven shuts down. We normally can unplug and replug a connector into the Sensor/Relay Watlow AnaFaze TLM-8 module and it sta
Electronics Forum | Mon Dec 22 13:54:25 EST 2014 | proceng1
My customer made a process change to overcome a design flaw. The PCB assembly mounts in a plastic housing. The PCB mounts to the front housing via plastic stand-offs. They had to change a connector on the back side of the assembly due to long term
Electronics Forum | Wed Oct 06 12:03:12 EDT 1999 | Graham Naisbitt
| | Hi, | | | | Help! Could anyone help to enlighten me on this? | | | | Question: | | | | If I have a CSP/BGA package of size X by Y and the standoff gap between the component and PCB is Z, What is the maximum allowable Y/Z or X/Z that using a n
Electronics Forum | Fri Dec 01 08:09:08 EST 2006 | CK the Flip
Square-leaded pin headers will typically bridge at the trailing edge (last couple of leads), since during peel-back, the solder at the trailing edge has "nowhere to go". If you have control over designs, ask your designers if they can put solder thi
Electronics Forum | Wed Mar 17 17:14:49 EST 1999 | Michael Allen
Another test to consider is dye penetrant analysis. The technique involves flooding the area beneath the soldered part with dye (preferably a bright color, like red). After drying the board+dye in an oven, you peel or torque the part off and inspec
Electronics Forum | Wed May 18 14:58:05 EDT 2005 | splice
Hi, I am having some PTH non wetting issues. Setup and chronology of events is explained: Set Up; Part: 1 MM pitch connector 378 pins Solder: Kester Ultra Pure 63/37 solder Pot; 250 C pre heat; Peak 94C top side Flux: Qualitek 775, Fluxer: foam T
Electronics Forum | Mon Oct 11 11:13:32 EDT 1999 | Wirat S.
| | | We've recently encountered this problem where one of our .050" pitch BGA's were reflowing at the wave thus causing shorts... The board was profiled with probes stuck to a QFP solder joint, an 0603, and one of the BGA joints. There was an almo
| 1 |
