Electronics Forum | Thu Feb 13 03:49:15 EST 2014 | jlawson
Yes all above is correct, as solder deposits get smaller and mesh T4+ , actual metal to air contact surface area increases , say in contrast to T3, add to this less flux , and flux running away from the joint, re-oxidation and what flux is left, can
Electronics Forum | Sat Jul 22 13:20:35 EDT 2023 | shrikant_borkar
Dear Abhishek, I too got the opportunity to investigate this defect Lift lead for SOT. Lead lift in IC, and SOT can occur due to various reasons. Here are some possible reasons for lead lift and ways to avoid them: During the assembly process, mecha
Electronics Forum | Thu Jun 25 09:37:48 EDT 1998 | Russ Miculich
The real causes of microcracking are not normally due to pick and place - particularly if you are using a piece of equipment with vacuum pick up and release. The real cause of microcracking is due to thermal stresses on the die and the choice of the
Electronics Forum | Mon Oct 26 02:00:36 EDT 2020 | chucherry5076
https://www.jrpanel.com/R The heat generated by electronic equipment causes the internal temperature to rise rapidly. If the heat is not dissipated in time, the equipment will continue to heat up and the components will overheat and fail, resulting
Electronics Forum | Thu Jul 22 22:18:12 EDT 2004 | davef
Notes from an AIM No-Lead Presentation ... Wave Soldering * May require a higher pot temperature than tin/lead: 255-265*C * May require a change in liquid fluxes to compensate for the poor wetting of some alloys and high thermal stresses of the wave
Electronics Forum | Mon Oct 14 12:56:50 EDT 2002 | davef
His technical contribution to the forum. From these 24 postings, we can see that 75% of Sean�s postings have a decided commercial bent, as followings: * Could be argued that the posting is a good technical response. Percent of postings 25%. * Could
Electronics Forum | Fri Jan 22 15:48:14 EST 1999 | Chrys
| Hello, | | I will be evaluating and qualifying two equipment types. The first is a fountain soldering device. I need practical advice on all the stuff you guys and gals know about as good, bad, ugly, best applications, setup, limitations, and all
1 |