Electronics Forum | Mon Nov 29 02:58:35 EST 2021 | erici
Our S25 is not booting up correctly. It is showing the 'software booting' status and will be stuck in that state. I checked the M/C pc and it is showing an SRBS SYSTEM HALTED error. Any ideas/help on this issue? Thanks
Electronics Forum | Mon Dec 06 17:03:10 EST 2021 | victorzubashev
Hi, Did you check if you can ping between MC and SR?
Electronics Forum | Mon Dec 06 21:57:09 EST 2021 | compit
make an IP address reservation for the MAC address of the machine on the DHCP server
Electronics Forum | Mon Dec 06 21:38:22 EST 2021 | erici
Thanks victor, will go with your suggestions. By the way, would you happen to have some info on how to work the MC distributor? When i was working on the hard drive of the machine i was able to re install the MC software on a fresh harddrive, as i u
Electronics Forum | Mon Nov 29 13:39:48 EST 2021 | oxygensmd
Is it a running machine or a first startup? For me, it seems to be some configuration error. For example problem with some card (iCos, MC, servo controller). At first check table and WPC connectors are fitted properly than check the status LEDs on y
Electronics Forum | Mon Nov 29 20:15:22 EST 2021 | erici
Thanks for the message. Yeah the machine was about to start-up when the problem happens. I will try your suggestions. Thanks again.
Electronics Forum | Mon Dec 06 21:40:39 EST 2021 | victorzubashev
Hi, Please send me your email to:victor.zubashev@qbotech.com I might have some instructions to share with you. Cheers, Victor
Electronics Forum | Mon Dec 06 22:10:28 EST 2021 | erici
Thanks for the reply michal, are you able to give me instructions on how to do this? Sorry complete newbie when it comes to networks. Thanks
Electronics Forum | Tue Dec 07 06:06:38 EST 2021 | compit
Each network has a device (server, router, etc.) on which the DHCP server is running - it is different in each network, so I will not help you - ask the IT specialist in your company.
Electronics Forum | Mon Dec 06 20:58:34 EST 2021 | erici
Hi victor, The power supply of the machine is giving us problems now, and so i cannot access anything at the moment. While working on the machine, the power on the machine suddenly started flickering and was causing the pc to shutdown as well. Have
.gif)
winsouce.jpg)
