Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Wed Dec 23 12:24:37 EST 2020 | ilavu
1. Palm down the GSM and open the safety cover to check input voltage +12VDC (at KDC2 3PL pins 2 to 3) and output voltage +5VDC (at KDC2 2PL pin 4 to 3) at the DC/DC converter. The DC/DC converter is located inside the control panel assembly ("Nose c
Electronics Forum | Thu Jun 23 21:04:04 EDT 2005 | darby
If you have concluded that it is not a file storage problem you may wish to consider - When setting up a job the camera can move to virtually any position. This does not mean that the actuators on the stencil or board have enough travel to align the
Electronics Forum | Sat Dec 17 15:46:28 EST 2005 | Csabee
Samsung SM320 don't have sensor for recognizing component. Only using Fly&Fix camera. In first time the korean samsung service engineer advised me (3,7light settings for chips and the machine generated many dumps, sometimes 50 or more per day. But n
Electronics Forum | Mon Sep 20 14:15:32 EDT 2010 | dekhead
"System Suspended While Cover is Opened" indicates front or rear cover opened; not the head being raised. Therefore there is an issue with one of the cover interlocks not being made properly. Note there are 2 switches on each (NO and NC) one goes int
Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead
No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom
Electronics Forum | Tue Oct 20 08:38:17 EDT 2015 | nhel_0009
good day, we're encountering trouble in CM602 Mounter and still looking for help..here is the error(cover open A stage front and rear, ext conv open/ConveyorHoleSensorDetect, Outside cover open, Momentary power off. Anyone knows the error ple
Electronics Forum | Sun Jan 17 10:27:01 EST 2021 | ecogroup
Thanks for replying Bukas...few days prior we found out it was the conveyor IF board. Changed it, all the contactors now engage. But now have these errors: Opened [SYSTEM] file is created by #1 machine. No command resonse from handler. (0x1000)
Electronics Forum | Thu Aug 28 09:45:48 EDT 2008 | leemeyer
What is the model of the machine, 1414, 1818 ?? What version of software are you running. There is probably a safety touch strip (yellow rubber strip)that is around the head and possibly the front sides of the machine. Check the connections and wirin
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
.gif)
winsouce.jpg)
