Electronics Forum | Mon Jul 16 16:42:40 EDT 2007 | pnguyvu
Hi Jacky, It seems you have solder bead problem, beading occurs when the solder paste brick splatter as a component is placed into it, after reflow, the splatter becomes a spherical solder ball. Hope this will help. Steve USA STENCILS
Electronics Forum | Thu Apr 12 00:43:38 EDT 2001 | zam_bri
Can anybody gimme some input on the problem I faced currently on 0402 Chip Resistor. At pre-reflow the component are placed nicely but at post reflow, we found the Resistor stands sideway ( both termination, the pad and componant are in contact, fun
Electronics Forum | Tue Jun 18 23:29:02 EDT 2019 | SMTA-David
Hi, I have an older Samsung pick and place (CP-40LV model). During last few runs I have experienced several feeders with the clear plastic tape cover not peeling back to expose the next part. I manually pull back the tape and it runs for a while and
Electronics Forum | Wed Jun 11 16:41:57 EDT 2014 | isd_jwendell
With Essemtec software you can specify to turn on vacuum once the nozzle is down at the part. The default method is to turn on the vacuum while the nozzle is up, but starting to move down. For light/tiny parts this can have the effect of making them
Electronics Forum | Thu Jun 22 11:42:29 EDT 2000 | Chrys Shea
Sal, Silly question: Were the parts skewed before they went into the oven? I've chased down a few similar reflow problems in my lifetime, only to find out it was a pick and place problem. Wrong nozzle size, bad nozzle, feeder not advancing all
Electronics Forum | Mon Mar 26 13:49:16 EDT 2007 | grantp
Hi, I don't know anyone who uses Mancorp, and apart from this forum have never heard of them. I guess the big problem I faced when getting into SMT is trying to find a machine that could do what we wanted at a good cost. I originally purchased MYD
Electronics Forum | Wed Jun 17 16:00:47 EDT 1998 | Frank
| | Does any one wave solder the 0402 Chips on the bottom side of a board? | | Any comments? | You will need to use a curable epoxy at the site of placement before placing the 0402--then cure the epoxy...possible problems are epoxy intrusion on the
Electronics Forum | Wed Jun 17 14:45:45 EDT 1998 | Bob
| Does any one wave solder the 0402 Chips on the bottom side of a board? | Any comments? You will need to use a curable epoxy at the site of placement before placing the 0402--then cure the epoxy...possible problems are epoxy intrusion on the lands
Electronics Forum | Mon Jan 08 03:47:47 EST 2007 | tk380514
as someone had said before, check you stencil and have it redesigned. I design our stencils for my factory and have inproved quality in BGA , QFP and 0603 case sizes. we did have 1 prototype series that used 0403 chips btu we had brand new feeders an
Electronics Forum | Tue Apr 27 23:10:16 EDT 2010 | mbrunton
I am looking at buying a pick and place machine to assemble the circuit boards we make. Most of the boards are small (2 to 10 square inches), most are 2 sided, and have maybe 20-50 parts per side. I use mostly 0805/0603 chips, SOT-23, SOD-123, SOIC
A dealer of high quality Used SMT Equipment, Used Plastic Injection Molding Equipment, Used Machine Tools, Used Semiconductor Machinery, and Used Industrial Machinery.
Equipment Dealer / Broker / Auctions
104 East Street
Middleton, MA USA
Phone: 978 790-2774
.gif)
