Electronics Forum | Fri Jul 13 12:21:41 EDT 2018 | emeto
The right way in your case is to use shield with cover. Place, reflow, remove shield pick up rails/tabs, AOI, close cover.
Electronics Forum | Wed Sep 08 20:38:06 EDT 1999 | Barbara
I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Thu Sep 15 10:49:58 EDT 2016 | emeto
Remove,clean, re-ball(or use new part), reflow. Body of the part is designed to withstand heat that is higher than the melting point of the balls alloy.
Electronics Forum | Thu Dec 13 16:18:29 EST 2001 | smtspecialist
I have a 10k thermistor to solder to a board, the problem is that the thermistor can't absorbe more then 105 degree C and as soon as I send it through the reflow oven or hand solder it, the part internaly over heat giving inconsistent readings. Any
Electronics Forum | Fri Sep 10 07:43:19 EDT 1999 | Christopher Cross
| I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Fri Sep 10 07:45:59 EDT 1999 | Christopher Cross
| | I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Wed Sep 08 21:36:14 EDT 1999 | kyung sam park
| I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Wed Sep 08 22:48:27 EDT 1999 | armin
| | I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Wed Sep 08 22:49:38 EDT 1999 | Jason Tomlinson
| | I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Thu Sep 09 10:09:15 EDT 1999 | John Thorup
| | | I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be don
.gif)
