Electronics Forum | Fri May 27 13:20:06 EDT 2016 | elton111
how are you. I have a problem with a table that the issue errori topaz. The issue is the message "Bring back component." a problem with the pick up parts vacum setting level is 100 and the current 111 with vacum head is 6. Can u tell me how to Calibr
Electronics Forum | Sat Mar 24 03:06:55 EDT 2007 | aj
Hi Mika, We came across some difficulties with this type of device a couple of years back . After the proto run we needed to touch up the outside fillets to get stability and product to pass test. ( even though the manf. stated that there is no fill
Electronics Forum | Thu Feb 15 13:46:16 EST 2018 | aemery
Griinder, Maybe it's me, but I think what you might be saying here is that you see a reflected image of the PCB or Stencil when you and teaching the fiducials and it is interfering with the teaching routine, is that correct? If this is true it is c
Electronics Forum | Wed Jan 27 08:39:07 EST 2016 | thefinder
Hi to all. i resolved my problem. I just select "LOAD" option the the program run.
Electronics Forum | Mon May 17 10:59:02 EDT 2021 | kumarb
Hi. Have an Emerald-X machine with FNC purchased refurb from Assembleon with mixed results at 3500 hours. Had it sitting idle for years due to assorted issues after their installation. Only now after much time and parts investment have the machinery
Electronics Forum | Tue May 18 09:58:17 EDT 2021 | kumarb
Thank you so much for the advice. We were suspecting blockage but know that we have clean nozzles. Did the air blow out and removed a spot of black matter - perhaps what was an old o-ring? Nozzles are 61 and 62 posing the issue. Our tech said that 64
Electronics Forum | Wed May 19 20:24:09 EDT 2021 | kumarb
Thank you Michal. Very much appreciated. We are thinking along the same lines. However, we are being very afraid to even cut the official wire ties that are securing the head 1 and head 2 wiring. We have a new VAC2 solenoid in transit that will arr
Electronics Forum | Fri Dec 02 08:10:25 EST 2005 | Amol Kane
Davef and russ, thank you for your input The kester was selected due to a management decision, I shall recommend that other solder be tried out as well. davef, i'll try out the soldering iron......and also look for the green tint (didnt notice that
Electronics Forum | Wed Oct 04 16:30:12 EDT 2006 | russ
I hope you are not trying to melt the Ceramic BGA columns. these are not meant to melt. I would run a lead process at peak temp of 225 -230C with lead paste. The board warpage may be of design issue or Manufacture issue. Russ
Electronics Forum | Thu Aug 02 14:10:55 EDT 2018 | jdengler
Could they be on the wrong axis from what they are configured for (X and Y swapped)? Jerry
winsouce.jpg)
