Electronics Forum | Mon Jan 31 13:02:43 EST 2005 | jgarver1
Do you have an extra VME Servo Board to try? Servo Overflows are not as common as Over Currents or hard amplifier failures. They seem to be resolved by replacing the servo board and not the amp or motor. My $.02
Electronics Forum | Tue Feb 06 12:32:20 EST 2007 | stephan
hallo , the orions servos are dc servos, the topas servos are AC servos the controller are mx1 and mx2 stephan from germany
Electronics Forum | Tue Mar 10 14:21:45 EDT 2009 | smellew
yes this would be normal as that is when the servo power is supplied for servo lock, do you have a new servo amp?
Electronics Forum | Thu Mar 07 03:32:32 EST 2013 | benreben
Hi, Can you move the X2 axis manually? if you move head manually(twice) can you see the pulse incremented in the servo menu in IP? with servo just have some parts can defects: -servo it self -servo board -encoder on head
Electronics Forum | Thu Sep 16 18:43:57 EDT 2010 | slwolbert
Hello Daxman, Thanks for the input. Yes, the CP2 is closely related to the CP4 and does have the analog servo amps as you deduced. I did a wiggle test on the connectors and found that the x-y-r servo amp alarmed right away and blinked the x axis a
Electronics Forum | Fri Sep 16 15:17:08 EDT 2005 | vikkaraja
Most likely servo amp is bad.
Electronics Forum | Tue Jan 24 16:35:16 EST 2017 | siltron
Hi everyone, We bought a used Juki KE a few months ago. Installed it at the beginning of this year, but have some problems with the Z and ROT servos. As soon as the machine is powered on, the ALM04 red led turns on on some of the Z and ROT drivers.
Electronics Forum | Wed Jun 21 04:11:31 EDT 2006 | daxman
Are you familar with using the mecca mode on Fuji machines? There is a procedure I can take you through that will check the servo amp and allow you to adjust it. Is your machine useable at all? can you get it to pass zero set? If you can, view your s
Electronics Forum | Thu May 21 20:25:26 EDT 2009 | voytek
I had to replace two Y-axis servo amplifiers on our GSM1 machine. I'm sitting on two faulty servos that I would like to have repaired. Let me know if you now place which specializes in repair of Servo Amplifiers Mod. No. 800-444 by Copley Controls.
Electronics Forum | Thu Aug 18 11:38:34 EDT 2011 | johndoe0222
I got this error message on the fuji IP3: " Servo limit over. Servo Z1 Axis +" I was wondering how to fix this error. Thanks.
winsouce.jpg)
