Electronics Forum | Wed Sep 04 10:10:10 EDT 2019 | jameshoward
I know exactly what your problem is as I have seen it many times. Your problem is with indexer 1 (the cylinder which runs up and down and actuates feeders on side 1). At each end of the travel of the indexer is a micro switch hidden down below the be
Electronics Forum | Wed Apr 07 11:36:41 EDT 2004 | stefwitt
Your machine will have to have a reference position. From this reference position, you determine all other machine positions. If the camera is attached to the head, you could place a glass slug and measure camera-nozzle offset, by placing the slug w
Electronics Forum | Wed Sep 21 15:13:08 EDT 2011 | gregcr
Where are you located? Along the same lines, I have a trick I used a couple times when replacing a camera. It is often not the image sensor that goes bad, but the camera electronics behind the sensor. I have had luck taking the camera apart but le
Electronics Forum | Thu Apr 08 23:08:56 EDT 2004 | Ken
Well, the precision glass is for upward looking camera's. It essentially is a "perfect part". Vapor deposition lithography on glass (for Cte stability)....basically the part pattern (or part fids) is compared to its target location (same pattern on
Electronics Forum | Thu Aug 08 18:21:21 EDT 2019 | Aaron
I recently purchased a contact systems 3, and 3s, and 4 of their 3zs. they were all used in various states of working. supposedly one 3s and 3z were working when taken out of service and had sat for a few months. another 3z had a homing issues and th
Electronics Forum | Fri Apr 20 09:52:25 EDT 2018 | ushir
Hey everyone, Ive recently discovered a problem where components picked are moving on a nozzle during the vision scan. Pick and Place being used is an iPulse M7-3L. When the scan camera scans across the components, the components are shifting on the
Electronics Forum | Mon May 16 22:06:22 EDT 2011 | danaherr
Downward looking camera not working. swapped cables on board and upward looking camera works when plugged into downward camera's connection on video card. Thinking maybe a cable issue??? manually moved gantry all over trying to see if intermitent ope
Electronics Forum | Tue Oct 09 06:14:48 EDT 2018 | bobpan
Move the camera over a feeder position and shine a flashlight to see if the image improves.....if it does....your light ring needs replaced or the led's need replaced in it. Sometimes just re-adjusting the angle of the led's in the ring can help. Go
Electronics Forum | Wed Jul 29 10:27:01 EDT 2015 | risorse_new
Goodmornin I have a problem with the fixing and move cameras, i don't see the image of the cameras on the screen. On the monitor i see the cross and letter, but i can no see on the black box the camera images. I know the problem is on the ADDA Board.
Electronics Forum | Tue Aug 11 09:55:49 EDT 2015 | rgduval
I'm no clock expert, but, even that unit you linked appears to have the period set by the weight on the pendulum. That unit notes that the pendulum is adjustable....though, I'm not sure how/what is adjustable...I would expect it to be the weight. I
.gif)
winsouce.jpg)