Electronics Forum | Tue May 07 08:35:43 EDT 2019 | paulanderson
I Have a SMTech/Quad MV100 Printer and it powers up and system on activates but does not go through home sequence - any ideas? All axis will move in the diagnostic mode
Electronics Forum | Wed May 08 06:43:07 EDT 2019 | paulanderson
I have also reset and checked all the inputs are working and all seem OK. Would be grateful if some one could confirm the home sequence, so I can at least start looking there first Thanks in advance
Electronics Forum | Wed May 08 09:23:34 EDT 2019 | paulanderson
Hi Bob, I already tried this :( Do you know the home sequence, as Im thinking it may be waiting for the first item to complete? Paul
Electronics Forum | Wed May 08 09:17:51 EDT 2019 | bobpan
push the 2 left buttons on the membrane panel after releasing the e-stop....this should get you into diagnostics....you then need to reset the system parameters. It may home then. good luck, Bob
| 1 |
.gif)
