Electronics Forum | Mon Jun 28 22:30:06 EDT 2004 | davef
If you find it at the end of your process and you find no defects, work on something else. Now if you are a smooth talker and seek a little adventure in life, you might be able to finesse this thing into a road trip to take a tour of your board fa
Electronics Forum | Wed Jun 23 13:34:29 EDT 2004 | df_indy
I am four weeks into my new job, there always seems to be some issues here with PCB every week. Today while I was checking some assemblies with micro-scope, I found a lot of tiny bubbles/blisters on the board. They are just little dots if you look
Electronics Forum | Mon Aug 09 18:03:28 EDT 1999 | Earl Moon
| | I am having cleaning problems when processing PCB's which have | | TAIYO solder mask on them. After processing, hand soldering and | | cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tide marks etc. Other solde
Electronics Forum | Tue Aug 10 07:28:49 EDT 1999 | Brian
| | | I am having cleaning problems when processing PCB's which have | | | TAIYO solder mask on them. After processing, hand soldering and | | | cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tide marks etc. Other
Electronics Forum | Tue Aug 10 15:19:55 EDT 1999 | Earl Moon
| | | | I am having cleaning problems when processing PCB's which have | | | | TAIYO solder mask on them. After processing, hand soldering and | | | | cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tide marks etc.
Electronics Forum | Tue Aug 10 15:47:34 EDT 1999 | John Thorup
| | | | | I am having cleaning problems when processing PCB's which have | | | | | TAIYO solder mask on them. After processing, hand soldering and | | | | | cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tide mark
Electronics Forum | Tue Aug 10 16:01:12 EDT 1999 | Earl Moon
| | | | | | I am having cleaning problems when processing PCB's which have | | | | | | TAIYO solder mask on them. After processing, hand soldering and | | | | | | cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tid
Electronics Forum | Fri Oct 30 10:36:26 EDT 2009 | richie_puthotta
Hi, I see a huge solder mask shift on chip comp pads. This would result in mid-chip solder balls or solder beads. Overall, the solder mask workmanship is not acceptable. Mask is on pad.
Electronics Forum | Sun Nov 01 23:51:44 EST 2009 | boardhouse
Hi Julie, My opinion is that the top board would not pass IPC, solder mask encroachment on pads. Second board is what we call Orange peel,this can be caused two way's. 1) the solder mask was not tack dried enough prior to imaging which caused artwo
Electronics Forum | Sun Nov 01 01:33:52 EST 2009 | isd_jwendell
Just my opinion: Top pic - Solder mask registration WAY too far off, without a doubt I would reject. Bottom pic - I would worry that there was/is a contamination that caused the poor looking mask. This may be cosmetic only, but unknown. I would rej
