Electronics Forum | Fri Jul 10 07:34:00 EDT 2020 | elijah
From the poor bonding strength of the board, the surface quality problems of the board are divided into: 1. The cleanliness of the board surface; 2. The problem of micro graphite (or surface energy) on the surface. PCB circuit board proofing Youke bo
Electronics Forum | Wed Oct 10 13:59:49 EDT 2007 | petep
I have always understood that on boards (or circuits) operating over 900 MHz, No Clean fluxes are to be avoided. Apparently the residues left behind, while non-conductive and non-corrosive, will change impedence of the circuit. It may be a possibil
Electronics Forum | Thu Oct 11 14:44:46 EDT 2007 | bbarton
Lots of papers out there on HiFreq circuits and the effects of solder paste residue. Google Dr. Karen Tellefsen. Simple test...take a "failed" board, remove the residues, test again. Has the problem gone away?
Electronics Forum | Mon Sep 27 11:40:50 EDT 2004 | grayman
use water soluble solder paste is the cure for your problem. but if you insist of using NC change your pogo pins to pointed pins.
Electronics Forum | Mon Sep 13 18:34:31 EDT 2004 | russ
Use Water soluble if you can, if not I would try the Indium SMQ NC paste, this residue stays soft. I would also change ICT probes to the "drill type". Russ
Electronics Forum | Sun Sep 12 08:30:29 EDT 2004 | davef
Well, another alternative is to use a water washable flux. If you insist on staying with a NC flux, use one that is probable. We prefer to probe solder, rather than copper.
Electronics Forum | Fri Sep 10 09:39:32 EDT 2004 | Bryan Sherh
Dears, I've a board with OSP surface finish,and I planned to print solder paste on the test pad for easy ICT, because the probe can't reach the OSP covered pad.But to my surprise,after reflow there's much flux residue on top of test pad(or solder) an
Electronics Forum | Tue Sep 14 08:14:07 EDT 2004 | Rob
Hi, There are "Fluxbuster" or "Rotator" pins on the market - we had to use them a few years ago on a flexy board (with OSP). There is some info from one source at the following link: http://www.isiconnectors.com/mfrs/idi/idipr.htm#Rotator We got
Electronics Forum | Sun Nov 04 05:11:14 EST 2007 | omidjuve
can you send me the articles about the high frequency boards issues with different types of solder paste alloy because i can`t find any free document about this article
Electronics Forum | Wed Oct 10 02:04:10 EDT 2007 | omidjuve
hi we use a no clean solder paste with the sn63pb37 alloy and our high frquency board doesn`t have any problem in test but after this product is finished now we use 2 different solder pastes 1. sn62 pb36 Ag.4 RA tape 2. NC type lead free with Ag i
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
