Electronics Forum | Wed Apr 20 18:45:36 EDT 2005 | Sue PH
Am looking for an easy way to solder in stacking connectors. Has any one found a way to wave solder these in, or even a simplified way to hand solder them in. Thanks for the help.
Electronics Forum | Fri May 31 09:13:12 EDT 2002 | russ
Jim, you are right in this. these connectors have long pins 1/2" or so that protrude through the board and are used for mating into a female connector on some other assembly. due to both length and "no solder allowed in contact area" criterias thes
Electronics Forum | Thu May 30 08:04:25 EDT 2002 | zanolli
Hello Russ, I'm not quite sure I understand your question. Are you saying that you must hand solder these connectors because the gold plating doesn't allow other though hole processing methods to wet the solder the length of the pin in the PTH? Reg
Electronics Forum | Fri Jul 24 16:37:47 EDT 2015 | cnotebaert
to my knowledge it will always be manual insertion,, if you mean reflow, not insertion, I always apply solder to one side, reflow, then apply tacky flux pre print to the already soldered pins, print op side, assemble part then send through placement
Electronics Forum | Fri May 31 14:02:23 EDT 2002 | dougt
Russ We decided to use a PC-104 brd for a piece of equipment and had to make a "PC-104 Adaptor Brd" as it is affectionately known. The actual PC104 connectors came with what they called a solder system, a flat piece of solder with holes in it that w
Electronics Forum | Thu May 30 08:51:45 EDT 2002 | davef
I assume the connector is like one used in PC104 that allows mating of boards together by inserting the pins extending from the connector on one board into the female portion of the connector on a second board. Who ever accepted this job is dopey.
Electronics Forum | Fri May 31 17:04:02 EDT 2002 | davef
We use boots / shunts er wutt ever you call them to protect solderable component surfaces from wave soldering. Not sure how it would work in your case try: * Kinnarney Rubber 450 Main St. P.O.Box 37 Mantua, N.J. 08051 609-468-1320 fax 7438 http://ww
Electronics Forum | Wed May 29 19:17:17 EDT 2002 | russ
We are starting to see a large increase in the use of through board gold plated connectors that require hand soldering with the limitation of .o6" encroachment up the pin. What is the best way to accomplish this? we currently scrap about 5-10% of t
Electronics Forum | Fri May 31 09:09:21 EDT 2002 | russ
Dave, you would be correct in this application. I wish I could prevent these products from coming into our shop, but... I do like the idea of press fit and I will have to research on the availability and persuade the customers to change. I was wond
Electronics Forum | Fri Apr 27 08:19:04 EDT 2012 | jim_n_hky
Can anyone offer guidelines on DFM and process recommendations for soldering .050" pitch connectors in the wave. The initail design had .026" drill with .043" pads so only .007" between pads. I requested .035" pads, but this still only leaves .015" b