Electronics Forum | Wed Sep 19 09:50:41 EDT 2007 | chrisgriffin
Have you tried doing a "weigh squeege" before printing?
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Fri Jan 12 13:56:59 EST 2001 | adrian
What is squegee snap off and how is it measured?
Electronics Forum | Fri Jan 12 16:29:22 EST 2001 | blnorman
Snap off is the distance from the top of the board to the bottom of the stencil.
Electronics Forum | Fri Sep 17 10:14:05 EDT 2004 | davef
Consider asking your stencil fab house to make replacement squeeges for you.
Electronics Forum | Wed Nov 06 06:46:27 EST 2019 | wippsen
Machine Calibration --> Pressure
Electronics Forum | Mon Nov 11 21:19:06 EST 2019 | dekhead
Knead pressure, is normally at or slightly lower (maybe 25%) than print pressure...
Electronics Forum | Fri Aug 28 09:27:08 EDT 2020 | serge_pirog
After 2-3 cycles error disappear.
Electronics Forum | Wed Sep 02 06:22:19 EDT 2020 | serge_pirog
Thank you very much.
Electronics Forum | Fri Jan 23 02:01:33 EST 2015 | dilogic
If someone has printer from subject, I have some questions regarding squeege holders (dimensions). I bought used one without squeege holders, found a company that can make it but I do not know exact fixing screw positions and height.
