Electronics Forum | Mon Mar 01 14:48:23 EST 2010 | g2garyg2
SUNSDA conveyors from China seem to have a special Chinese PLC control board that also requires a Chinese laptop and special chinese only software to make PLC changes. Just wondering if anyone knows how to access the PLC to make timer changes vs. fl
Electronics Forum | Tue Sep 14 17:49:36 EDT 2010 | g2garyg2
The problem with the Sunsda units is that they use a special circuit board, not PLC and Chinese software for programming, so getting into the program to find out what is going on is a problem. Have you replaced the SMEMA cable? I have seen bad ones.
Electronics Forum | Wed Sep 01 16:33:33 EDT 2010 | smellew
Mike, I don't know this loader, but if you link 3&4 locally on the downstream conveyor, this should make it request PCB from loader via 1 & 2 PCB should then unload.
Electronics Forum | Thu Sep 02 20:41:03 EDT 2010 | mmccance
SME, Thanks for your response, but I have already checked out 1 & 2 on the downstream conveyor, and they are sending the machine ready signal. I know that the loader is recieving it because when the downstream conveyor is not busy the loader attemp
Electronics Forum | Wed Sep 01 14:45:57 EDT 2010 | mmccance
Has anyone had any experience with SANSDA? We have a board loader that was bought used with no documentation. We have tried to contact them requesting schematics or a SMEMA manual to no avail. The loader is not completing the circuit telling the d
1 |