Electronics Forum | Tue Jul 04 20:31:21 EDT 2017 | davef
If you want in, 5-21h Bottom Termination Components (BTC) Task Group is in "Working Draft" revision from "A" to "B" of IPC-7093 - Design and Assembly Process Implementation for Bottom Termination SMT Components
Electronics Forum | Thu Mar 21 16:50:58 EDT 2019 | andyharrold
I'm trying to identify the type of pluggable terminal block used on this circuit board. Any help greatly appreciated
Electronics Forum | Fri Mar 22 11:14:46 EDT 2019 | robl
Doh! but any other 14A+ pluggable terminal block would fit in it's place (compliance permitting), you'd just need to unscrew the cables in the mating half, and change that to the new type on the board.
Electronics Forum | Wed Jun 26 14:33:52 EDT 2019 | slthomas
Do you have any images that show the soldered terminations? Also images of the pcb terminations after the part has moved might be helpful.
Electronics Forum | Mon Aug 19 09:42:41 EDT 2019 | edhare
Dave, Perhaps, but my interpretation of that photo is that it simply shows a knit line fracture that propagated out to the surface. The fact that it shows on the termination is not surprising since the termination wraps around the internal plate st
Electronics Forum | Fri Jan 15 07:23:14 EST 2021 | denism
Also, solder splashes can be due to contamination, for example, on the terminals of components. In the past, had a problem with solder splashes on a seemingly standard SMD component. The reason was the incorrect nickel plating process of the componen
Electronics Forum | Tue May 30 21:14:31 EDT 2000 | Dave F
Sal: JAX makes good points, but I�d like to think about this differently. It sounds like the poorly soldered connection is lifting the whole connector, so that termination floats on top of the solder, rather than submit to the wetting force and be
Electronics Forum | Thu Jul 20 15:37:53 EDT 2000 | Tekguy2000
These parts are flat chip resistor arrays that have 4 end terminations on each side. It looks liek an IC but is typically in an 0805 and 1206 package type with convex terminations. .031" pitch from termination to termination and .011" spacing between
Electronics Forum | Mon May 03 09:42:45 EDT 1999 | Mike McMonagle
| Tombstoning 0805s w/palladium/platinum/silver terminations | | We are experiencing tombstoning problems on 0805 packages that have paladium/platinum/silver terminations. It comes & goes...... | | I�ve checked the reflow profile, and paste deposi
Electronics Forum | Sat Jul 19 12:22:55 EDT 2008 | operator
Are there any softwares OR functions inside of the softwares that allow a designer that is creating a very large complicated wiring diagram with say....many terminal blocks and connectors etc... to run a point to point check on his drawing? Bascially
.gif)
winsouce.jpg)