Electronics Forum | Wed Jul 20 22:59:34 EDT 2016 | ttheis
I had something similar to this on a different type of machine but it turned out to be a broken wire terminal connector at the switch causing intermittent connection. Often with safety circuits they are kept high and brought low or interrupted to dis
Electronics Forum | Tue May 07 14:33:57 EDT 2013 | cyber_wolf
The "lowest" acceleration is probably causing your problem. Switch it to the next fastest setting and see what happens
Electronics Forum | Tue Mar 31 15:14:53 EDT 2009 | kpm135
Is your machine an inline system with the conveyors along the back? If so I have run into this problem before with the sensors on the covers for the conveyors. They are 'magnetic' safety switches that can appear to be closed but don't actually switch
Electronics Forum | Thu Jul 07 11:55:03 EDT 2005 | meritajs
Hi, We have problem with ABU IPTE,it indicate Emergency stop, Break,but we can not find all safety switches and sensors because do not have safety drawing. Could somebody help us?
Electronics Forum | Wed Dec 22 12:01:27 EST 2021 | cuervo
hello i have a juki 2060 an a error E620001 EMERGENCI STOP appears on screen an there is no switch pressed can someone help me , my pick and place is dead
Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Fri Aug 28 12:46:04 EDT 2020 | inspiredmorris20
Greetings all, my cp45 pnp machine is down this morning, gives me the code 0002 (front EME switch pressed). operator said they did not E-Stop, reset the unit and reboot the S/W a few times. the code pops up as soon as the software loads. I can turn
Electronics Forum | Mon Dec 05 09:14:14 EST 2022 | peterm
Invoke. The PTF Setup Procedure dialog box displays. 4. Select Product. The Select Product File dialog box displays. 5. Select the same product used in the Open PTF Teach Product section above. 6. Enter the Slot number for the PTF and select Full
Electronics Forum | Mon Aug 31 15:21:04 EDT 2015 | zombee
Dear Users! I have a Topaz pick&place machine, but the conveyor motor is not working. 1st test - production: Start production in "operation" menu: if I put the PCB the entrace of machine, the assembly head-bank picks up the first 8 components (prec
Electronics Forum | Fri Jul 17 07:50:32 EDT 2009 | csm
Dear Jepoy We check the oilmatic system and I found a relay is not working, it will arrive until tomorrow. We still have 2 errors and 1 message, we are taking time because we don't have the Fuji CP6-4000 manuals or electric diagrams. we get this ma
