Electronics Forum | Sun Mar 24 17:28:20 EDT 2013 | vikkaraja
Thanks for all the help you are giving me but I just can't put my finger on this annoying problem. I checked and recheck all sensors without much sucess against the I/O. Something I am not understand is these two followning conditions--- first one I
Electronics Forum | Wed Feb 10 12:37:14 EST 2021 | dontfeedphils
In a past life we had "board catchers" who stood at the end of our two lines and caught the boards. They were also in charge of transporting the boards to wash and loading/unloading the wash as well. I was never a fan of this approach, bu
Electronics Forum | Wed May 21 20:58:48 EDT 2003 | star7483
APPLICATION: SMT CARRIER TAPE FEATURE: �� High efficiency: joining is accomplished without shutting off the machine. The SMT machine can increase output 5%-15%. �� Reducing SMT machine and feeder abrasion: There is no need to unload & reload feeder
Electronics Forum | Mon May 02 11:00:34 EDT 2005 | jh0n!
Unfortunately, we don't have that option under Utilities. Must be UP-2000 specific. I've set everything up correctly, multiple times...All the right dimensions, etc, taught fids, and it still tries to load the board in the wrong position. As far a
Electronics Forum | Thu Jan 31 16:29:26 EST 2013 | markhoch
I had the exact same issue a few years ago at my last place of employment. It happened twice within two months on two seperate peices of Crown-Simplimatic Equipment. I immediately sorced and replaced every lithium battery in all of my Loaders, Unload
Electronics Forum | Tue Dec 12 12:03:39 EST 2017 | dleeper
A lot of it depends on what machines you are using and how well they implement dual lane feeders. A few general comparisons: Pros: -You can fit more feeders on your machines. -One dual lane feeder is cheaper than two single lane feeders Cons: -two
Electronics Forum | Sat Mar 08 02:23:09 EST 2003 | Frank
My two Process Engineers are at odds with each other. One says that the Tact Time is only the actual Pick-n-Place time to build a board, and the other says it needs to include the load/unload time as well as the Fiducial reading time. Example: So
Electronics Forum | Wed Apr 09 15:05:45 EDT 2003 | russ
Probably of no help but here it is anyway This is a tuff one. Attrition is due to many factors. You have machine rejects (visual fail, no pick), feeder set-up loss each time a reel is removed you lose X number of parts depending on feeder design (w
Electronics Forum | Thu Apr 15 16:13:13 EDT 2004 | pjc
Best recommendation is to compare the two machines with your boards and stencils. Either vendor should be able to arrange for a �test drive� at one of their demonstration facilities or at a local friendly customer. I�m afraid that your request for �o
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
