Electronics Forum | Fri Jun 16 17:30:04 EDT 2000 | Eutectic state
Go with Universal. We had Fuji equipment for years. That is all but phased out now and we only are buying Universal. You cannot beat their service. The chip shooters are great. The only cons that I have dealt with is the learning curve on the n
Electronics Forum | Wed Dec 17 10:24:51 EST 2003 | kauerr
Hey, go to http://www.uic.com it is the Universal Instruments website. Universal sells HSP 4796 machines. These are actually Sanyo TCM 3000 Machines. We have 4 of them, they are awesome machines. Hope this helps, Curt
Electronics Forum | Fri Nov 09 14:34:30 EST 2001 | vickt
As mentioned in other replies, the Universal GSM has expanded capabilities....As for the UIC HSP's....the 4796L can handle an 18" x 20" panel as standard, and has options to go up to 18" x 24.5". Did I mention that the 4796L places at a 0.10 tact ti
Electronics Forum | Thu Jan 14 10:25:36 EST 1999 | J. Coogan
Doug The 4796A and 4796R machines maintain maximum tact time within an XY table movement window of approximately 17mm. In addition, due to their ability to perform "on-the-fly" theta correction, they are also able to maintain top speed for a larger
Electronics Forum | Wed Sep 10 09:56:18 EDT 2003 | vickt
5 years ago (mostly likely 7-8 yrs). Most of these failures can be attributed to simple overtemp conditions or mechanical stress. Customers who do not keep the cooling fan filters clean on their machines tend to see a higher failure rate due to highe
Electronics Forum | Wed Apr 27 09:28:16 EDT 2011 | dittmann
Hi all, I would like to know, how can I check out, if this types of machines below, have GEM interface? Where and exactly how can I check it out on each of this machines? -Universal GSM2 4688A -Universal HSP 4796L -Hitachi GXH-3 -Hitachi GXH-1S -Hita
Electronics Forum | Tue Nov 01 09:24:06 EST 2005 | UIC HSP Techs
The problem you report is very uncommon. Nozzles falling out of the placement heads can only be caused by severe mis-adjustment or failed parts. The following items should be checked: 1) Nozzle position hooks (on placement heads) 2) Clutch solenoid/
Electronics Forum | Wed Jun 11 16:30:33 EDT 2003 | T.Vick
You have received some great feedback so far. I would like to summarize and add a few points regarding maintenance. You should start (as recommended already) by verifying your component library data. Using the default values from the master library i
| 1 |
