Electronics Forum | Wed Jun 10 15:10:55 EDT 1998 | Rich
I am looking for the Industry standards on vias. Are they required to be plated with solder or is copper plating enough? What about reliabilty with either one? Also, if tenting the via is required should it be copper plated or solder plated over c
Electronics Forum | Thu Oct 01 11:40:17 EDT 1998 | Justin Medernach
Are there anyone who can give me the answer about solder ball problem? | We have 12 layer PCB and double sided PCB. After one side reflow soldering We found lots of solder ball under the PCB. The solder ball was coming out from via hole. | So
Electronics Forum | Tue Sep 22 09:07:02 EDT 1998 | Steve Gregory
Hi Jacqueline! Do these joints that you're having problems with happen to be on fine pitch solder joints? Are the fillets staying attached to the foot and separating from the pads cleanly? If that is true, are there many vias concentrated aroun
Electronics Forum | Mon Oct 21 19:17:23 EDT 2013 | hegemon
The first picture shows an issue. Note that the vias adjacent to the interior rows are filled with solder. At the outside rows this is not evident. What you might have are interior spheres that are smaller in volume than the rows on the outide, si
Electronics Forum | Tue Jul 15 16:12:23 EDT 2008 | boardhouse
Hi Armynski, I sell for an offshore board house, yes, it is common for offshore board shops to fill vias. The bubble is caused by air entrampment within the hole it self, when heat is applied during Hot air and the via is covered on both sides the e
Electronics Forum | Tue Sep 29 04:54:23 EDT 1998 | Clive Heke
Thank you Steve for your input it was very usefull. I think I skipped a few pertinant details on my initial message though, the component which we found the flux contamination on was on the top side of the board, I was curious if the flux could come
Electronics Forum | Tue Mar 03 09:29:48 EST 2015 | rgduval
A couple of things that have helped me with solder ball issues at wave in the past: 1. Flux. Insure good flux coverage on the bottom of the board. 2. Preheat. Insure that the board is sufficiently preheated for the wave operation. Since you're
Electronics Forum | Thu Nov 25 21:43:49 EST 1999 | cklau
Via is normally a plated thru holes in (0.63 to 1.0 mm (0.025" to 0.040") diameter lands , which unless properly treated they must be located away from the component lands to prevent the solder migration off the component land during reflow soldering
Electronics Forum | Tue Dec 14 01:05:09 EST 1999 | cklau
Hi All I have a 0.7 mm diameter hole for vias, what�s the minimum annular ring for this hole diameter? Ans: Fur inner layers Min = .006" hole-pad annular ring ; inner pad dia - hole dia/2 For outer layers Min = .005" hole-pad annular ring ; outer p
Electronics Forum | Fri Apr 12 17:22:47 EDT 2002 | davef
First, splitting hairs on parlance. * Conformal Coating. A thin electrically nonconductive protective coating that conforms to the configuration of the covered assembly to provide environmental and mechanical protection. * Solder Mask. Coating mate
