Electronics Forum | Tue Jul 29 22:13:59 EDT 2008 | davef
IPA is a fire hazard. Be sure your fire extinguishers are charged and your evacuation plan is current, when using IPA in the vacinity of a wave solder machine. Have you tried DI water? Solutions used in wave finger cleaners include: * Techspray SMT
Electronics Forum | Tue Jul 29 14:20:04 EDT 2008 | jstano
What chemical is everybody using in their wave solder finger cleaner? I have tried IPA as well as some other chemicals. Any suggestions?
Electronics Forum | Wed Jul 30 09:07:14 EDT 2008 | grics
Zestron's Vigon RC-101...Good with no clean
Electronics Forum | Wed Jul 30 12:13:38 EDT 2008 | allwave
You may want to try C8502 from Kyzen Corp. I use it on our three wave solder machines with great results diluted in DI water 50%. I am an end-user like you not a sales person! You can order free samples... -George
Electronics Forum | Thu Jul 31 02:40:20 EDT 2008 | JH pbf
We use Axarel 2200 as recomended by Vitronics Soltec, which is the same as we use on our MPM printes for under stencil cleaning. It is non-ozone depleating and has a high flash point. For insurance purposes we banned IPA from the shop floor some
Electronics Forum | Thu Jul 31 07:53:34 EDT 2008 | ck_the_flip
Jon, Does Axarel 2200 leave minimal residue or clumps on the wiper paper area? Also, what is your wipe frequency on a typical board?
Electronics Forum | Fri Aug 01 09:44:42 EDT 2008 | pjc
Try Zestron Vigon RC 101. This mixes with tap water. Electrovert does not recommend DI water due to its corrosive nature. http://www.zestron.com/fileadmin/zestron/overviews-tis/usa/ti/ti-vigon-rc101-usa.pdf
Electronics Forum | Wed Jul 30 10:48:39 EDT 2008 | wavemasterlarry
Degeaser isn't a good chemical to use either cause it leaves a residue so don't use it. alcohol works good. Not sure why everyone thinks it blows up. heck i remeber back in the day when I hade 24 inch foam fluxers bubbling flux and alcohol (IPA no
Electronics Forum | Tue Jul 13 08:17:54 EDT 2010 | davef
We expect to find recommendations on periodic maintenance from the equipment fabricator in the operating manual. Those recommendations should be the basis for you to setup your maintenance program.
Electronics Forum | Mon Jul 12 17:52:18 EDT 2010 | warwolf
Hello Our company has just bought a EWS 500 F XL wave machine (about 8 months ago) and i have been trained on how to use it so in new to the industry, things are going well so far but im a bit stumbled on the simplest thing and that’s weather or not
