Electronics Forum | Fri Sep 08 12:03:24 EDT 2017 | rameshraja
Hi, I need the RF 800 Flux Acid titration procedure and also require EPT of the same to add thinner ( RF 800 additive), i.e we are using the flux rf 800 for our wave soldering process having foam fluxer , after 2 hours we are taking sample from the
Electronics Forum | Thu Jul 05 14:00:21 EDT 2007 | wayne123
we have recently been having trouble with our PPS capacitors on a couple of our boards. these boards are RoHs and the Parts are RoHs compliant. these boards first run through our reflow then a batch washer some through-hole parts are placed and then
Electronics Forum | Tue Feb 01 09:53:37 EST 2005 | Howard Sommerfeld
I also have a spreadsheet tool for comparative analysis using criterion weighted scoring. It can be used to analyze any decision, and helps groups reach consensus on why a particular alternative is the way to go. As final steps you can also consider
Electronics Forum | Fri Jan 28 12:18:32 EST 2005 | Chunks
Your best bet is to do a decision making matrix. Each company has so many different criteria�s it's hard to pick out which one might be important to yours. Simply pick out your top 5 paste manufactures. Next decide what your "Eliminators" are - th
Electronics Forum | Wed Dec 20 04:43:36 EST 2006 | greg york
Any decent flux would volatise off with the heat of the wave unless absorbed into the solder mask. Test this by trying to clean in alcohol or common solvent aerosol, if it does not clean then it is probably Mineral Salts from solder mask fillers. Ano
Electronics Forum | Thu Jul 06 03:03:56 EDT 2006 | ronalds
Thank you all for your input. The MF300S Multicore flux is rated for lead free. There is not much dross or contamination. We are using nitrogen. I've tested the boards with the curing test of IPC-TM-650. I think you're all right about the preheat.
Electronics Forum | Fri Jul 14 14:26:04 EDT 2017 | davef
How to clean Durostone wave solder pallet? Add date：2016-1-13 Hits：657 Print Back Ultrasonic machines are often used to clean the pallets. This machine is suitable to eliminate the wax, the oil and other stains. With high efficiency, excellent clea
Electronics Forum | Fri Sep 14 03:43:16 EDT 2012 | mili
Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leg
Electronics Forum | Thu Jun 14 15:29:29 EDT 2012 | davef
That you can get good solder flow when hand soldering seems to indicate that the temperature of your solder pot is too low. Still, I'm uneasy that you see gold on the pads after passing the board across the solder pot. Gold is so thin with ENIG. So
Electronics Forum | Thu Jul 25 14:32:55 EDT 2019 | bulur
What does flux acid value means in SMD and PTH applications? Is it higher acid values better for each application?
.gif)
winsouce.jpg)
