Electronics Forum | Tue May 08 09:50:19 EDT 2007 | patrickbruneel
Hi Loco, Good point!! The good old glass plate works just fine as long as the conveyor or carriers have L shaped fingers. A glass plate is usually about a � inch thick (a lot thicker than the actual board). With L shaped fingers the bottom of the gl
Electronics Forum | Sun Apr 19 13:52:45 EDT 1998 | D.Lange
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components Robert, PPI
Electronics Forum | Sun Apr 19 13:50:41 EDT 1998 | D.Lange
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components Robert, PPI
Electronics Forum | Sat Apr 25 19:40:01 EDT 1998 | Stan Traxler
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components We have appl
Electronics Forum | Tue Apr 28 14:50:43 EDT 1998 | Chrys
| | We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | | PCb substrate to compensate for thermal stressing in a | | Space enviroment. Has any one any ideas or contacts for | | dissolvable pads. this only applies to leadless components | Ro
Electronics Forum | Thu Sep 26 23:14:25 EDT 2013 | zsoden
We picked up this old (circa late 80s) Seho 1135 machine last year for next to nothing. It needed a bit of TLC to bring it back to working order but it's 99% working now. The only problem left is that we cannot get sufficient height from the delta wa
Electronics Forum | Fri Jun 08 01:25:02 EDT 2018 | buckcho
Hello, good choice! Koh young makes great reports for cpk. Only one advice. If you take 50panels from production and your cpk seems low, try to group the different kinds of components. Because also cpk on a whole panel would be not good number as wel
Electronics Forum | Mon Dec 17 12:06:58 EST 2007 | pjc
5 Steps to Eliminate Bridges: 1. Establish (wave) Parallelism First and foremost, you must establish board-to-wave parallelism. This is the prerequisite to any wave solder process control. For an understanding of the power of this approach go to ht
Electronics Forum | Mon May 07 22:28:17 EDT 2007 | colormaker
radiant heat. 137c The hollis was a great machine. The one I had the prehead wass on or off there was no setting. The pot temperature guage was brocken so I had to guess and manually turn the heater on and off. The whole machine was covered with 1 i
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
