Electronics Forum | Mon Feb 20 09:20:07 EST 2006 | dpmilk
It appears to us that the problem lies in the lead-free solder paste rather than the inductors. We have not found a lead-free solder that does not do this. The green is on the copper wire. We believe it gets there during the reflow. The gasses fr
Electronics Forum | Tue Feb 28 10:18:35 EST 2006 | Steve Gregory
I just went through the same problem. We have an inductor that is made with a bundle of 30-strands of Litz wire that is vaccuum coated with varnish, and have the ends of the wire bundles tinned that we have to solder to SMT pads on the board. The ind
Electronics Forum | Thu Oct 05 15:58:16 EDT 2006 | RusH
Mario, Thanks for your response. We are building a leaded assembly with hot air leveled Sn/Pb pads on the PCB. In one case the component is a 7.5X5.2X1.8 wire wound ferrite inductor with Au/Sn leads. The second component is an 0808 Tantalum cap,
Electronics Forum | Wed Aug 13 19:57:05 EDT 2014 | suroy
After wash cycle, some of the inductors are open (broken wire). Resistance across the two ends should be below 4 ohms (normal) however on broken wire shows above 200 ohms. I am wondering if anyone else has seen this problem. We are using High-Reliabi
Electronics Forum | smith88 |
Sat Dec 11 16:38:14 EST 2021
Electronics Forum | Tue Sep 26 07:46:49 EDT 2023 | robertanderson
A transformer winding machine is a specialized piece of equipment used in the manufacturing of transformers. Transformers are electrical devices that transfer electrical energy between two or more circuits through electromagnetic induction. They cons
Electronics Forum | Tue Aug 04 10:43:48 EDT 2009 | kpm135
Thanks for the suggestions! It ended up being that a wire on the amplifier card in the lower drawer came loose and was making intermittent contact. Tightened all the wires down and the problem has gone away. Now we have a new problem. We had to repla
Electronics Forum | Fri Nov 11 09:38:41 EST 2005 | Rob
Hi, There are 2 main steps to reducing EMI from a product. The first is to minimise it at source with smart design (keeping signal traces short, lots of decoupling etc). There should be design guides available from internet seach engines. Many ma
Electronics Forum | Wed Oct 10 13:51:08 EDT 2007 | petep
Coilcraft has posted the following and I am wondering how you folks are handling the use of coils in a Water Soluble world. PCB Washing and Coilcraft Parts Coilcraft tests for resistance to solvents per the following specification: Resistance to s
| 1 |
winsouce.jpg)
.gif)
