Electronics Forum | Tue Aug 20 07:35:04 EDT 2002 | bmulcahy
Hi, I guess you a looking for a manual x-y table with a vacuum pick up such as SMT6000 from OK industries. I presume these are still being made-- We use one successfully at the end of a Mydata machine to place low volume components which we cannot j
Electronics Forum | Fri Sep 20 05:17:10 EDT 2002 | byates
What are the error codes?? you dont even know if it is the vision type until you have checked this out. It could be camera lighting. Do you know how to use vision trace on your machine? What is your x&y tolerance? What about vision 254 or 255 have yo
Electronics Forum | Mon Nov 17 08:01:44 EST 2003 | stefwitt
The format is X,Y Theta of the component center for all placement machines. Gerber data can be useless, unless you have the reference from pin 1 to the component center. Some machines offer a CAD convertion tool. I don't know any machine, which can
Electronics Forum | Thu Apr 29 14:41:12 EDT 2004 | pjc
OK if the paper is transparent and you can adjust the table X-Y-Theta under the paper- without moving the paper - the align with the solder lands on the board. If you have a DEK or MPM machine, the Mylar frame is like $300. I belive other printer mfr
Electronics Forum | Thu May 13 09:47:32 EDT 2004 | Lubo
We are looking for a inspection system to check the positioning of a component over a PCB. We need it positioned both in X Y directions and height above PCB (it is a TH component) to be within certain limits. PLS advise can this be achived by AOI. Wh
Electronics Forum | Tue Jul 13 14:47:35 EDT 2004 | cyber_wolf
I have a brand new X/Y/Theta table for an SPM(The one that uses magnetic supports) that I would like to trade for an older version table.(The one that has holes drilled and tapped in it.) the one I trade for has to be in good condition. No stripped h
Electronics Forum | Wed Aug 04 10:19:51 EDT 2004 | davef
Consider: * Reducing the size of the pads * Reducing the amount of solder paste * Inspecting the print. A print with irregular form (eg, print finishes with a tail, the print is inclined or something like that) * Too long in the reflow zone * Bad ali
Electronics Forum | Wed Jul 06 08:32:11 EDT 2005 | aj
Doug, Why not insist on the smae fromat from all customers. They can export center cad-data as easy as any other type. Do you send a DFM to your customers? If you tell them that it will improve your turn around time they will send you what you wan
Electronics Forum | Mon Mar 14 10:38:02 EST 2005 | ???
Are you absolutely sure that you changed the x-y ribbon cables....the z is controlled through those cables and almost all the time one of the cables has an intermittent open. I think there is a small card in the top of the machine (under the black co
Electronics Forum | Fri Apr 15 16:02:26 EDT 2005 | jdengler
ING, If my memory is correct: -This is from the large air cylinder below the X/Y table moving slow or not getting down all of the way. -The air cylinder has a sensor for when it's down all of the way. - This sensor could be bad but most of the t
