Electronics Forum | Wed Jun 15 19:46:15 EDT 2022 | mikevb
Hey All. I figured it out. It turns out that the problem was simply a loose coupler on the x wagon motor transducer. I had only checked one screw in the past but the other screw was apparently loose as well.
Electronics Forum | Sun Jun 12 01:38:47 EDT 2022 | mikevb
I'm having a problem with my Mydata My9 pick and place. Basically whenever I try to run the placement calibration program or try to have the machine find fiducials, or basically anything with precision, the machine displays a X MOT motor timeout erro
Electronics Forum | Tue Jun 14 15:59:25 EDT 2022 | mikevb
Thanks! I just needed a response like that. I will do all that, and if it's still an issue, I'll change the x wagon encoder right? There are three encoders on the x wagon though? The white one on the x carriage, the white one on the x belt drive mo
Electronics Forum | Sun Jun 12 01:44:59 EDT 2022 | mikevb
I forgot to mention that I've measured and adjusted the cog play on the x axis and so it is within range, if that applies.
Electronics Forum | Tue Jun 14 15:02:13 EDT 2022 | glasscake
Start with fundamentals: Disconnect, clean and reconnect all inner connections, bulk heads, ext. Disconnect, reconnect all connections at the controller. Check wiring harness for conductivity. Clean everything appropriately, lube ways, balls screws
Electronics Forum | Tue Jun 14 16:23:22 EDT 2022 | glasscake
Cant put a finger on it being an encoder that was just a single possibility. You can always hook up a scope to the encoder and see if they are working appropriately. I would look through the machine's utilities and see if there is some debug or more
Electronics Forum | Sat May 29 14:03:18 EDT 2010 | padawanlinuxero
Hello guys! I have a problem I had to change the MI Board on a MYDATA TP9-4 machine because it was firing 3 or more feeders at the same time, after the change it run great but then for some reason after a while it start to show an error message that
Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho
Electronics Forum | Wed Aug 07 13:32:21 EDT 2019 | rgduval
To isolate the MOT failure, try swapping the MOT card with another MOT card. If the failure moves, then the problem is in the card. If the failure does not move, the MOT card is not your problem. If the MOT card is not the issue, then your problem
Electronics Forum | Thu Aug 14 13:49:26 EDT 2014 | dyoungquist
Motor control MSETDYN -> Initiate axis C -> Centering jaws 156 -> Motor timeout Did not reach specified position Hardware problem Looks like you have something wrong with the movement of your centering jaws.
winsouce.jpg)
