Electronics Forum | Tue Mar 18 09:09:37 EST 2003 | pjc
The FGLV has a air pressure displacement valve, which is designed for adhesives. A positive displacement valve is better suited for solder pastes. Check with Fuji to see if they offer optional valves.
Electronics Forum | Fri Aug 04 09:48:37 EDT 2023 | boyabandaoti
The pneumatic control valve can be roughly divided into different valves: pneumatic ball valve, pneumatic butterfly valve, pneumatic gates valve, pneumatic intercept valve, and so on. The first two are switching methods of angle strokes, and the latt
Electronics Forum | Tue May 18 09:58:17 EDT 2021 | kumarb
Thank you so much for the advice. We were suspecting blockage but know that we have clean nozzles. Did the air blow out and removed a spot of black matter - perhaps what was an old o-ring? Nozzles are 61 and 62 posing the issue. Our tech said that 64
Electronics Forum | Thu Oct 08 17:07:43 EDT 2020 | dwl
Its been a while, but as I recall, there are two air valves under the table. one controls the exit speed, and one controls the entrance. You just need to fiddle with the valve until it travels at a decent speed.
Electronics Forum | Wed Mar 27 16:03:01 EDT 2019 | jdengler
Jim, It's been a long time since I worked on one of these so this is going to be a general idea as to the issue. There's a solenoid valve that is controlled by the E-stop ckt. When in E-stop in stops air from entering and vents the pressure lines
Electronics Forum | Thu Nov 29 15:52:53 EST 2007 | jmelson
Some other machines are a lot simpler. Here's how the Philips (mady by Yamaha) CSM84 works. Smaller tape (8 and 12 mm) feeders are all mechanical. A plunger on the head pushes a lever on the feeder at the same time the head comes down. First, the
Electronics Forum | Thu Sep 02 13:19:52 EDT 2010 | remullis
I am having issues with the air dump on this machine. When you palm down or break interlocks the air dumps as it should however I'm getting a short burst of air back through the system. The problem with this is it's just enough to trigger the table l
Electronics Forum | Tue Oct 04 23:36:47 EDT 2016 | mrpackethead
How big an air compressor is needed to run Some Yamaha YS100 machines? What kind of air quality is required.
Electronics Forum | Wed Oct 15 16:34:36 EDT 2008 | gregcr
Hi All, I am retrofitting a machine with a solder paste dispenser head, and am trying to decide what direction to go, with a dispense valve. The choices I know are either a standard Air over, or some kind of positive displacement valve such as a sc
Electronics Forum | Fri Aug 24 07:21:51 EDT 2012 | leemeyer
The barbed fitting will work but you will lose all control over the speed of the cylinder. The air control flow valve is essentially the same as the barbed fitting but it allows the user to adjust the volume of air that is supplied to the cylinder wh
