Electronics Forum | Sat Jun 25 01:05:13 EDT 2005 | pci
check the X axis belt , guides and Z axis motor
Electronics Forum | Mon May 30 11:37:01 EDT 2005 | stepheniii
I don't know this machine but I have seen a similar problem on other machines. Have you cleaned and lubed the guide rods for the x-axis? It's easy to forget that AOI machines do need some maintenance. Is it possible that it hangs, while waiting for t
Electronics Forum | Fri Oct 27 03:02:54 EDT 2017 | praveenmuthusamy
Dear All, what might be the reasons for servo alarm on W axis in YXI(X RAY INSPECTION MACHINE)?? MAKER: YAMAHA TYPE: KLC-0000 NOTE:MACHINE CANNOT BE RESET UNLESS POWER SHUTDOWN. MACHINE RETURNS TO NORMAL STATE ONCE POWER SHUTDOWN AND RESATARTED! R
Electronics Forum | Tue Oct 11 18:21:36 EDT 2005 | stepheniii
Does it do nozzle changes at a different speed than the programs? It's been a while since I worked on these beasts. I"m wondering if it can handle slow speeds but at full bore it can't handle it. Maybe try one part with everything set to slow speed
Electronics Forum | Tue Sep 19 22:45:19 EDT 2006 | darby
Larry, The Quad is based on the Samsung - yes? If so, here are the final recommended answers from Samsung. All LM guides and bearings, ball splines and rack and pinion use Shell Alvania EP2. Sometimes called LF2. Sometimes called Albania. It's a dar
Electronics Forum | Thu Jul 07 19:39:18 EDT 2005 | darby
This is a very difficult question to answer as it will depend greatly on your component mix. I will presume that the CSM 84VZ is of the following configuration: 2 x RDC Synchro Heads. Heads 1 & 2. These are mechanically centering heads with a chucki
Electronics Forum | Thu Nov 01 17:24:20 EDT 2007 | jmelson
I think the Yamaha 84S is very similar to my Philips CSM84. head 3 cannot reach all the feeder locations. I believe feeder locations 1-3 on the front rail, and is it 41-43 on the back rail (the first 3 again) are out of range for the X axis to move
Electronics Forum | Fri Jan 14 16:22:05 EST 2000 | JAX
The feeders that you are probably refering to are made by hoover-davis. They only have adjustable pitch( electronic ). You probably will not find a universal feeder that has adjustable width. This is because the guide track is positioned on the left
Electronics Forum | Thu Sep 24 00:52:41 EDT 2015 | ermani9
Hi.. Move the XY arm to the center of the machine. Turn on the servo then immediately hold “LOWER” then press “ORIGIN”. You should see the message now on the screen “DRIFT CHECK”. The arm will start to drift without an emergency condition occurr
Electronics Forum | Wed Nov 09 23:02:34 EST 2011 | jeffr
Tom, I cannot find the software to operate my Sunshine EPROM burner right now. It is safe for you to read out the files on each of the ROMs using your burner. It is just a plug in, plug out operation to get the machine going again. The machine will s
.gif)
.gif)
