Electronics Forum | Tue May 07 20:29:55 EDT 2019 | airheart5959
Hi to all, Please help me where can I get any training manuals / operations manual of this Yamaha yg200 machine. I want to learn how to operate this machine and do troubleshooting. Your help will be appreciated. Thanks and regards, Airheart
Electronics Forum | Thu Mar 22 01:59:16 EDT 2018 | boskoncam
Dear, Good day! Currently, we are sourcing the English version service manual for YG200/YG300/YV180XG SMT machines . If you are available to provide for us , pls contact with us at any time. Thanks and best regards, Jenny Email: jenny@ksunsmt.co
Electronics Forum | Sun Jun 09 19:02:15 EDT 2002 | Ken G.
Sam, I can tell you right now that if you have a low volume hi mix application where the program/job is changing every day, an AXI system is not going to be a good fit. As you alluded to, the programming time is onerous, the fine tuning or tweaking i
Electronics Forum | Fri Jan 19 20:55:56 EST 2007 | Mike Konrad
The answer depends on the cleaning / defluxing method. There are many fine chemicals available. One must first consider the cleaning method, then safety (environment and operator), then cost. For automated board cleaners (defluxers), consider th
Electronics Forum | Fri Feb 11 18:51:16 EST 2005 | primus
The operators use SET SEQ and SET SEG. I know all about getting these wrong, because if you forget the "Q" or the "G" you get SET SE which is SET SENSOR. That REALLY messes up our BEC! But then again, I believe our BECs are all calibrated wrong anywa
Electronics Forum | Fri Mar 16 11:52:31 EST 2001 | J.D. of Panasonic
Ed, You certainly are ready for some equipment. I noticed in your message that you mentioned cost three times. So it is a very big issue to you. What everything depends on is where you see your company going in the next few years. Do you want
Electronics Forum | Tue Mar 09 13:11:00 EST 1999 | Nancy
Maybe it is all what you get use to. Our assemblers like the vacuum pen. Since we do more than passive components, some parts would be difficult to hold and line up. As for as our Fristch, we use it as a manual and just have our bins on the side.
Electronics Forum | Mon Jun 19 22:19:40 EDT 2006 | Nathan
Dear All, We plan to setup an assembly line for our small volume production of PCBs (about couple hundred PCBs per week). The board has about 150 components (less than 30 types) and a few BGA and IC (majority is SMT, only few THT connectors). We hav
Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching
Electronics Forum | Thu Oct 12 22:16:59 EDT 2000 | Dreamsniper
Hi Guys, I'd like to share this to all of you...you can start playing with the rests...Stated prices, if not indicated, are in Aussie $ or Singapore $. Stencil Printing Adhesive Pros a) Less Capital Equipment Cost (Short Term). In reality it is f
