Electronics Forum | Fri Jan 12 08:41:12 EST 2007 | geb
Hi, Our GSM1 pick and place machine has an Axis head 2 Z velocity error. None of the spindles of Head 2 work during placement and it brings up the error message. It will not proceed after that. I have tried lowering and raising the spindles in the
Electronics Forum | Thu Jan 18 10:05:44 EST 2007 | SWAG
Make sure the program has been optimized to the current nozzle configuration.
Electronics Forum | Mon Jan 15 11:12:08 EST 2007 | jaimebc
I've had experienced this issues here with our GSM's Flex heads. Try this: 1.- Clean your linear scales with alcohol and a lint free cloth. Both the X and Y. This one has fixed the majority of our errors when one of the heads just stops for no apare
Electronics Forum | Thu Jan 18 14:02:51 EST 2007 | geb
Thanks for your help everyone. For some reason it has started working again, without altering the program or settings!!?? So I don't actually know why it has done this. Thanks again, Grant
Electronics Forum | Sat Jan 13 19:34:16 EST 2007 | geb
(Its a flex head) I have made a trial program to determine at what point it stops. This is how it goes: I load the program, push the start button it will zero and pick components with head 1. As soon as it finishes placing head 1 parts it halts wher
Electronics Forum | Fri Jan 12 11:04:09 EST 2007 | mika
zero > in manual Control > bring the head close to the end of the machine so that you can reach the head => Diagnostic meny > engage the clutches and THIS IS VERY IMPORTANT: use Extreme Caution (you can flip off the X-Y circuit braker on the lower ba
Electronics Forum | Mon Jun 20 18:36:42 EDT 2005 | jsloot
Does anyone have any experience with a QUAD Meridian 1010? Our company has purchased a used machine. We have it installed and running almost smoothly. Getting an error code 3487, description is "Z axis target position in motion board is strange" Anyo
Electronics Forum | Sat Jul 08 02:10:31 EDT 2023 | unsung
Wipe down and clean the 2 Gold strips on Y Axis and the encoder ( located on both sides of the machines covers must be removed ) Probably has dirt happen to someone who had an old universal 2007 that was sitting outside in the open air for a few day
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Fri Jul 07 17:33:25 EDT 2023 | jdengler
Since you haven't received any useful advise I will throw my 2 cents in. I do not know this machine but in general what you describe is an axis that does not get it's home pulse in time. Many machines will have an in-range sensor that gets flagged
