| http://etasmt.com/te_news_industry/2021-09-15/26561.chtml
Low Force Placement Solutions for Advanced Packaging-SMT Technical-Reflow oven,SMT Reflow Soldering Oven-cmsadmin Home About I.C.T News Products Video Projects Service Join Us Contact Us Home About I.C.T
| http://etasmt.com/te_news_industry/2021-09-01/24564.chtml
. The plating thickness is too thin or the result of poor processing, which can be easily damaged during assembly; The soldering temperature is not high enough
| http://etasmt.com/cc?ID=te_news_bulletin,23574&url=_print
>> News Circuit Board Voids & PCB Delamination Circuit Board Voids Circuit Board Voids are cavities or air pockets inside the solder joint formed by gases that are released during reflow or by flux residues that fail to escape
| http://etasmt.com/te_news_bulletin/2021-08-31/23574.chtml
& PCB Delamination From: Author: Publish time:2021-08-31 17:39 Clicks:16 Circuit Board Voids Circuit Board Voids are cavities or air pockets inside the solder joint formed by gases that are released during reflow or by flux residues that fail to escape from the solder before it solidifies
| http://etasmt.com:9060/te_news_bulletin/2021-08-31/23568.chtml
. Their formation is promoted by excessive oxides in the solder paste that inhibit solder coalescence during reflow. Solder ball defects are probably the most common reflow solder defect, and there are many causes of solder ball defects beyond the system that will contribute to their formation
| http://etasmt.com/te_news_bulletin/2021-08-31/23568.chtml
. Their formation is promoted by excessive oxides in the solder paste that inhibit solder coalescence during reflow. Solder ball defects are probably the most common reflow solder defect, and there are many causes of solder ball defects beyond the system that will contribute to their formation
Heller Industries Inc. | https://hellerindustries.com/voids/
Circuit Board Voids Home » Circuit Board Voids Re-printed in partnership with ITM Circuit Board Voids Circuit Board Voids are cavities or air pockets inside the solder joint formed by gases that are released during reflow or by flux residues that fail to escape from the solder
| http://etasmt.com/cc?ID=te_news_bulletin,23568&url=_print
: solder balls Solder balls are very small fines of solder that have separated from the main body that forms the joint. Their formation is promoted by excessive oxides in the solder paste that inhibit solder coalescence during reflow
| http://etasmt.com:9060/te_news_industry/2019-05-28/6361.chtml
. If the viscosity is too high or too low, the printing quality will be affected. The storage environment of the solder paste requires the temperature to be maintained at 0-5 ° C
| http://etasmt.com/cc?ID=te_news_bulletin,11361&url=_print
vehicles.Components were mechanically redesigned to have small metal tabs or end caps that could be directly soldered to the surface of the PCB. Components became much smaller and component placement on both sides of a board became far more common with surface mounting than through-hole mounting, allowing much higher circuit densities and
