| http://etasmt.com/cc?ID=te_news_bulletin,23571&url=_print
• Improper pad trace • Improper solder mask application • Via in pad draining solder from connection • Trace with solder mask over it running under component causing a fulcrum effect on the component
| http://etasmt.com/te_news_bulletin/2021-08-31/23576.chtml
(non-shiny) solder joints are usually the effect of coarse grain structure in the solid solder joint (though there can be other causes
| http://etasmt.com/cc?ID=te_news_media,10561&url=_print
. The heating effect will be better than the smaller reflow soldering. Therefore, when purchasing reflow soldering, the first thing to look at is the temperature zone
Blackfox Training Institute, LLC | https://www.blackfox.com/4-common-errors-in-smt-assembly/
process, eventually reducing the likelihood of these errors. 1. Bridging Solder bridging happens when a solder accidentally connects two electrical conductors that should not be connected, often resulting in a short circuit
| http://etasmt.com:9060/te_news_bulletin/2020-11-13/20561.chtml
. Almost all electronic products have been applied. Reflow soldering is in English. Reflow is a soft solder that realizes mechanical and electrical connection between the solder ends of surface mount components or the pins and the printed board land by remelting the solder paste pre
| http://etasmt.com/te_news_bulletin/2020-11-13/20561.chtml
. Almost all electronic products have been applied. Reflow soldering is in English. Reflow is a soft solder that realizes mechanical and electrical connection between the solder ends of surface mount components or the pins and the printed board land by remelting the solder paste pre
| http://etasmt.com:9060/te_news_media/2019-09-02/10561.chtml
. The heating effect will be better than the smaller reflow soldering. Therefore, when purchasing reflow soldering, the first thing to look at is the temperature zone
| http://etasmt.com/te_news_media/2019-09-02/10561.chtml
. The heating effect will be better than the smaller reflow soldering. Therefore, when purchasing reflow soldering, the first thing to look at is the temperature zone
| http://etasmt.com:9060/te_news_bulletin/2021-08-31/23571.chtml
• Improper pad trace • Improper solder mask application • Via in pad draining solder from connection • Trace with solder mask over it running under component causing a fulcrum effect on the component
| http://etasmt.com/te_news_bulletin/2021-08-31/23571.chtml
• Improper pad trace • Improper solder mask application • Via in pad draining solder from connection • Trace with solder mask over it running under component causing a fulcrum effect on the component
winsouce.jpg)