Electronics Forum | Sun Feb 12 03:06:04 EST 2012 | dan_ems
Please help me with this: I need a zero Ohm SMD resistor (strap) to connect 2 PCBs but to be like a wire, that can be bent. I need to be SMD because I want to be place it with "pick and place machine". Thank you.
Electronics Forum | Tue Nov 13 04:47:19 EST 2018 | dhammika
hi Siplace Hs-60 defected due to below error Error- • Machine error:2271 Can bus: reception call aborted with time out seg:0 DEV: head 2 #:1 (this is not only head 2 ,error raise with all head interm
Electronics Forum | Thu May 31 21:45:48 EDT 2012 | davef
rsthompson ... if you're talking about bare boards IPC-5701, Users Guide for Cleanliness of Unpopulated PBC, Table 8 ||Bare board final surface finish Ions||Hot air solder level||OSP over copper||Gold over nickel Chloride||0.75 ug/cm^2||0.75 ug/cm^2
Electronics Forum | Fri Oct 03 09:00:18 EDT 2003 | davef
EIA standard packages have a variety of L/W proportions. EIA||Dimension mm (LXW)||Proportion (L/W) 0201||0.6X0.3||2 0202||0.5X0.5||1 0303||0.8X0.8||1 0402||1.0X0.5||2 0504||1.25X1.0||1.25 ||1.4X1.4||1 0603||1.6X0.8||2 0805||2.0X1.25||1.6 1111||2.8X2
Electronics Forum | Fri May 02 09:49:19 EDT 2003 | tommyg_fla
3NaH2PO3 + H2SO4 + 2H2 + Ni^0 Potassium is co-deposited with the nickel, as follows: H2PO2^- + Hads => H2O + OH^- + P 3H2PO2^- + P => H2PO3^- + H2O + 2OH^- What is Hads?
Electronics Forum | Wed Feb 01 02:21:26 EST 2017 | rob
80 micrometres (0.08mm) or 80 mil (2mm)? Smallest I've seen reliably printed is around 0.2mm x 0.4mm (01005 pad) and 0.2mm x 0.2mm CSP pad, not seen anything dispensed below 0.35ish, but we are not cutting edge.
Electronics Forum | Mon Jan 03 09:10:46 EST 2005 | russ
That would be a 2012 (2.0mm x 1.2mm) in accordance with standardized naming convention.
Electronics Forum | Mon Feb 22 12:04:15 EST 1999 | Dave F
| Please could you suggest a recommended aperture sizes for | printing of smd adhesives. Any recommendations on stencil thickness as well as stencil finish will be appreciated. | Mark: About the only rule of printing adhesives is: Keep it off the
Electronics Forum | Thu Mar 15 22:17:17 EDT 2012 | daniel26
AMS 2.0 contact assemblon its expensive but works great for our machines.
Electronics Forum | Wed Dec 21 20:41:49 EST 2016 | epcb2016
1.5mm pad is not so ok in practice. You may expand the size to 2.0mm.